projects / deliverable / linux.git / blame
| Commit | Line | Data |
|---|---|---|
| 736b1c9c DD |
1 | * General Purpose Input Output (GPIO) bus. |
| 2 | ||
| 3 | Properties: | |
| 4 | - compatible: "cavium,octeon-3860-gpio" | |
| 5 | ||
| 6 | Compatibility with all cn3XXX, cn5XXX and cn6XXX SOCs. | |
| 7 | ||
| 8 | - reg: The base address of the GPIO unit's register bank. | |
| 9 | ||
| 10 | - gpio-controller: This is a GPIO controller. | |
| 11 | ||
| 12 | - #gpio-cells: Must be <2>. The first cell is the GPIO pin. | |
| 13 | ||
| 14 | - interrupt-controller: The GPIO controller is also an interrupt | |
| 15 | controller, many of its pins may be configured as an interrupt | |
| 16 | source. | |
| 17 | ||
| 18 | - #interrupt-cells: Must be <2>. The first cell is the GPIO pin | |
| 19 | connected to the interrupt source. The second cell is the interrupt | |
| 20 | triggering protocol and may have one of four values: | |
| 21 | 1 - edge triggered on the rising edge. | |
| 22 | 2 - edge triggered on the falling edge | |
| 23 | 4 - level triggered active high. | |
| 24 | 8 - level triggered active low. | |
| 25 | ||
| 26 | - interrupts: Interrupt routing for each pin. | |
| 27 | ||
| 28 | Example: | |
| 29 | ||
| 30 | gpio-controller@1070000000800 { | |
| 31 | #gpio-cells = <2>; | |
| 32 | compatible = "cavium,octeon-3860-gpio"; | |
| 33 | reg = <0x10700 0x00000800 0x0 0x100>; | |
| 34 | gpio-controller; | |
| 35 | /* Interrupts are specified by two parts: | |
| 36 | * 1) GPIO pin number (0..15) | |
| 37 | * 2) Triggering (1 - edge rising | |
| 38 | * 2 - edge falling | |
| 39 | * 4 - level active high | |
| 40 | * 8 - level active low) | |
| 41 | */ | |
| 42 | interrupt-controller; | |
| 43 | #interrupt-cells = <2>; | |
| 44 | /* The GPIO pin connect to 16 consecutive CUI bits */ | |
| 45 | interrupts = <0 16>, <0 17>, <0 18>, <0 19>, | |
| 46 | <0 20>, <0 21>, <0 22>, <0 23>, | |
| 47 | <0 24>, <0 25>, <0 26>, <0 27>, | |
| 48 | <0 28>, <0 29>, <0 30>, <0 31>; | |
| 49 | }; |