Commit | Line | Data |
---|---|---|
684ae39b LD |
1 | TPS62360 Voltage regulators |
2 | ||
3 | Required properties: | |
4 | - compatible: Must be one of the following. | |
5 | "ti,tps62360" | |
6 | "ti,tps62361", | |
7 | "ti,tps62362", | |
8 | "ti,tps62363", | |
9 | - reg: I2C slave address | |
10 | ||
11 | Optional properties: | |
684ae39b LD |
12 | - ti,enable-vout-discharge: Enable output discharge. This is boolean value. |
13 | - ti,enable-pull-down: Enable pull down. This is boolean value. | |
14 | - ti,vsel0-gpio: GPIO for controlling VSEL0 line. | |
15 | If this property is missing, then assume that there is no GPIO | |
16 | for vsel0 control. | |
17 | - ti,vsel1-gpio: Gpio for controlling VSEL1 line. | |
18 | If this property is missing, then assume that there is no GPIO | |
19 | for vsel1 control. | |
f21ccfa0 | 20 | - ti,vsel0-state-high: Initial state of vsel0 input is high. |
684ae39b | 21 | If this property is missing, then assume the state as low (0). |
f21ccfa0 | 22 | - ti,vsel1-state-high: Initial state of vsel1 input is high. |
684ae39b LD |
23 | If this property is missing, then assume the state as low (0). |
24 | ||
25 | Any property defined as part of the core regulator binding, defined in | |
26 | regulator.txt, can also be used. | |
27 | ||
28 | Example: | |
29 | ||
30 | abc: tps62360 { | |
31 | compatible = "ti,tps62361"; | |
32 | reg = <0x60>; | |
33 | regulator-name = "tps62361-vout"; | |
34 | regulator-min-microvolt = <500000>; | |
35 | regulator-max-microvolt = <1500000>; | |
36 | regulator-boot-on | |
37 | ti,vsel0-gpio = <&gpio1 16 0>; | |
38 | ti,vsel1-gpio = <&gpio1 17 0>; | |
39 | ti,vsel0-state-high; | |
40 | ti,vsel1-state-high; | |
41 | ti,enable-pull-down; | |
42 | ti,enable-force-pwm; | |
43 | ti,enable-vout-discharge; | |
44 | }; |