Commit | Line | Data |
---|---|---|
790edb61 G |
1 | config UNICORE32 |
2 | def_bool y | |
e00ca515 | 3 | select ARCH_MIGHT_HAVE_PC_PARPORT |
d444b03b | 4 | select ARCH_MIGHT_HAVE_PC_SERIO |
790edb61 G |
5 | select HAVE_MEMBLOCK |
6 | select HAVE_GENERIC_DMA_COHERENT | |
790edb61 G |
7 | select HAVE_DMA_ATTRS |
8 | select HAVE_KERNEL_GZIP | |
9 | select HAVE_KERNEL_BZIP2 | |
82e54a6a | 10 | select GENERIC_ATOMIC64 |
790edb61 G |
11 | select HAVE_KERNEL_LZO |
12 | select HAVE_KERNEL_LZMA | |
4febd95a | 13 | select VIRT_TO_BUS |
7563bbf8 | 14 | select ARCH_HAVE_CUSTOM_GPIO_H |
790edb61 G |
15 | select GENERIC_FIND_FIRST_BIT |
16 | select GENERIC_IRQ_PROBE | |
37daf322 | 17 | select GENERIC_IRQ_SHOW |
790edb61 | 18 | select ARCH_WANT_FRAME_POINTERS |
4673ca8e | 19 | select GENERIC_IOMAP |
786d35d4 | 20 | select MODULES_USE_ELF_REL |
790edb61 G |
21 | help |
22 | UniCore-32 is 32-bit Instruction Set Architecture, | |
23 | including a series of low-power-consumption RISC chip | |
24 | designs licensed by PKUnity Ltd. | |
25 | Please see web page at <http://www.pkunity.com/>. | |
26 | ||
790edb61 G |
27 | config GENERIC_CSUM |
28 | def_bool y | |
29 | ||
ce816fa8 | 30 | config NO_IOPORT_MAP |
790edb61 G |
31 | bool |
32 | ||
33 | config STACKTRACE_SUPPORT | |
34 | def_bool y | |
35 | ||
36 | config HAVE_LATENCYTOP_SUPPORT | |
37 | def_bool y | |
38 | ||
39 | config LOCKDEP_SUPPORT | |
40 | def_bool y | |
41 | ||
42 | config RWSEM_GENERIC_SPINLOCK | |
43 | def_bool y | |
44 | ||
45 | config RWSEM_XCHGADD_ALGORITHM | |
46 | bool | |
47 | ||
48 | config ARCH_HAS_ILOG2_U32 | |
49 | bool | |
50 | ||
51 | config ARCH_HAS_ILOG2_U64 | |
52 | bool | |
53 | ||
790edb61 G |
54 | config GENERIC_HWEIGHT |
55 | def_bool y | |
56 | ||
57 | config GENERIC_CALIBRATE_DELAY | |
58 | def_bool y | |
59 | ||
60 | config ARCH_MAY_HAVE_PC_FDC | |
61 | bool | |
62 | ||
446d141e GX |
63 | config ZONE_DMA |
64 | def_bool y | |
65 | ||
790edb61 G |
66 | config NEED_DMA_MAP_STATE |
67 | def_bool y | |
68 | ||
69 | source "init/Kconfig" | |
70 | ||
71 | source "kernel/Kconfig.freezer" | |
72 | ||
73 | menu "System Type" | |
74 | ||
75 | config MMU | |
76 | def_bool y | |
77 | ||
78 | config ARCH_FPGA | |
79 | bool | |
80 | ||
81 | config ARCH_PUV3 | |
82 | def_bool y | |
83 | select CPU_UCV2 | |
84 | select GENERIC_CLOCKEVENTS | |
85 | select HAVE_CLK | |
86 | select ARCH_REQUIRE_GPIOLIB | |
790edb61 G |
87 | |
88 | # CONFIGs for ARCH_PUV3 | |
89 | ||
90 | if ARCH_PUV3 | |
91 | ||
92 | choice | |
93 | prompt "Board Selection" | |
94 | default PUV3_DB0913 | |
95 | ||
96 | config PUV3_FPGA_DLX200 | |
97 | select ARCH_FPGA | |
98 | bool "FPGA board" | |
99 | ||
100 | config PUV3_DB0913 | |
101 | bool "DEBUG board (0913)" | |
102 | ||
103 | config PUV3_NB0916 | |
104 | bool "NetBook board (0916)" | |
79c11b6f TR |
105 | select PWM |
106 | select PWM_PUV3 | |
790edb61 G |
107 | |
108 | config PUV3_SMW0919 | |
109 | bool "Security Mini-Workstation board (0919)" | |
110 | ||
111 | endchoice | |
112 | ||
113 | config PUV3_PM | |
114 | def_bool y if !ARCH_FPGA | |
115 | ||
116 | endif | |
117 | ||
118 | source "arch/unicore32/mm/Kconfig" | |
119 | ||
120 | comment "Floating poing support" | |
121 | ||
122 | config UNICORE_FPU_F64 | |
123 | def_bool y if !ARCH_FPGA | |
124 | ||
125 | endmenu | |
126 | ||
127 | menu "Bus support" | |
128 | ||
129 | config PCI | |
130 | bool "PCI Support" | |
131 | help | |
132 | Find out whether you have a PCI motherboard. PCI is the name of a | |
133 | bus system, i.e. the way the CPU talks to the other stuff inside | |
134 | your box. Other bus systems are ISA, EISA, MicroChannel (MCA) or | |
135 | VESA. If you have PCI, say Y, otherwise N. | |
136 | ||
137 | source "drivers/pci/Kconfig" | |
138 | ||
139 | source "drivers/pcmcia/Kconfig" | |
140 | ||
141 | endmenu | |
142 | ||
143 | menu "Kernel Features" | |
144 | ||
790edb61 G |
145 | source "kernel/Kconfig.preempt" |
146 | ||
147 | source "kernel/Kconfig.hz" | |
148 | ||
149 | source "mm/Kconfig" | |
150 | ||
151 | config LEDS | |
152 | def_bool y | |
76ec9d18 | 153 | depends on GPIOLIB |
790edb61 G |
154 | |
155 | config ALIGNMENT_TRAP | |
156 | def_bool y | |
157 | help | |
158 | Unicore processors can not fetch/store information which is not | |
159 | naturally aligned on the bus, i.e., a 4 byte fetch must start at an | |
160 | address divisible by 4. On 32-bit Unicore processors, these non-aligned | |
161 | fetch/store instructions will be emulated in software if you say | |
162 | here, which has a severe performance impact. This is necessary for | |
163 | correct operation of some network protocols. With an IP-only | |
164 | configuration it is safe to say N, otherwise say Y. | |
165 | ||
166 | endmenu | |
167 | ||
168 | menu "Boot options" | |
169 | ||
170 | config CMDLINE | |
171 | string "Default kernel command string" | |
172 | default "" | |
173 | ||
174 | config CMDLINE_FORCE | |
175 | bool "Always use the default kernel command string" | |
176 | depends on CMDLINE != "" | |
177 | help | |
178 | Always use the default kernel command string, even if the boot | |
179 | loader passes other arguments to the kernel. | |
180 | This is useful if you cannot or don't want to change the | |
181 | command-line options your boot loader passes to the kernel. | |
182 | ||
183 | If unsure, say N. | |
184 | ||
185 | endmenu | |
186 | ||
187 | menu "Userspace binary formats" | |
188 | ||
189 | source "fs/Kconfig.binfmt" | |
190 | ||
191 | endmenu | |
192 | ||
193 | menu "Power management options" | |
194 | ||
195 | source "kernel/power/Kconfig" | |
196 | ||
790edb61 | 197 | source "drivers/cpufreq/Kconfig" |
790edb61 G |
198 | |
199 | config ARCH_SUSPEND_POSSIBLE | |
200 | def_bool y if !ARCH_FPGA | |
201 | ||
202 | config ARCH_HIBERNATION_POSSIBLE | |
203 | def_bool y if !ARCH_FPGA | |
204 | ||
205 | endmenu | |
206 | ||
207 | source "net/Kconfig" | |
208 | ||
209 | if ARCH_PUV3 | |
210 | ||
211 | config PUV3_GPIO | |
212 | bool | |
213 | depends on !ARCH_FPGA | |
c2844646 | 214 | select GPIO_SYSFS |
790edb61 G |
215 | default y |
216 | ||
fa7499ef G |
217 | if PUV3_NB0916 |
218 | ||
219 | menu "PKUnity NetBook-0916 Features" | |
220 | ||
221 | config I2C_BATTERY_BQ27200 | |
222 | tristate "I2C Battery BQ27200 Support" | |
8889023a | 223 | select I2C_PUV3 |
fa7499ef G |
224 | select POWER_SUPPLY |
225 | select BATTERY_BQ27x00 | |
226 | ||
227 | config I2C_EEPROM_AT24 | |
228 | tristate "I2C EEPROMs AT24 support" | |
8889023a | 229 | select I2C_PUV3 |
fa7499ef G |
230 | select EEPROM_AT24 |
231 | ||
232 | config LCD_BACKLIGHT | |
233 | tristate "LCD Backlight support" | |
234 | select BACKLIGHT_LCD_SUPPORT | |
235 | select BACKLIGHT_PWM | |
236 | ||
237 | endmenu | |
238 | ||
239 | endif | |
240 | ||
790edb61 G |
241 | endif |
242 | ||
243 | source "drivers/Kconfig" | |
244 | ||
245 | source "fs/Kconfig" | |
246 | ||
247 | source "arch/unicore32/Kconfig.debug" | |
248 | ||
249 | source "security/Kconfig" | |
250 | ||
251 | source "crypto/Kconfig" | |
252 | ||
253 | source "lib/Kconfig" |