firmware: qcom: scm: Split out 32-bit specific SCM code

[deliverable/linux.git] / drivers / firmware / qcom_scm.c

/* Copyright (c) 2010, Code Aurora Forum. All rights reserved.
 * Copyright (C) 2015 Linaro Ltd.
 *
 * This program is free software; you can redistribute it and/or modify
 * it under the terms of the GNU General Public License version 2 and
 * only version 2 as published by the Free Software Foundation.
 *
 * This program is distributed in the hope that it will be useful,
 * but WITHOUT ANY WARRANTY; without even the implied warranty of
 * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the
 * GNU General Public License for more details.
 *
 * You should have received a copy of the GNU General Public License
 * along with this program; if not, write to the Free Software
 * Foundation, Inc., 51 Franklin Street, Fifth Floor, Boston, MA
 * 02110-1301, USA.
 */

#include <linux/cpumask.h>
#include <linux/export.h>
#include <linux/types.h>
#include <linux/qcom_scm.h>

#include "qcom_scm.h"

/**
 * qcom_scm_set_cold_boot_addr() - Set the cold boot address for cpus
 * @entry: Entry point function for the cpus
 * @cpus: The cpumask of cpus that will use the entry point
 *
 * Set the cold boot address of the cpus. Any cpu outside the supported
 * range would be removed from the cpu present mask.
 */
int qcom_scm_set_cold_boot_addr(void *entry, const cpumask_t *cpus)
{
	return __qcom_scm_set_cold_boot_addr(entry, cpus);
}
EXPORT_SYMBOL(qcom_scm_set_cold_boot_addr);

/**
 * qcom_scm_set_warm_boot_addr() - Set the warm boot address for cpus
 * @entry: Entry point function for the cpus
 * @cpus: The cpumask of cpus that will use the entry point
 *
 * Set the Linux entry point for the SCM to transfer control to when coming
 * out of a power down. CPU power down may be executed on cpuidle or hotplug.
 */
int qcom_scm_set_warm_boot_addr(void *entry, const cpumask_t *cpus)
{
	return __qcom_scm_set_warm_boot_addr(entry, cpus);
}
EXPORT_SYMBOL(qcom_scm_set_warm_boot_addr);

/**
 * qcom_scm_cpu_power_down() - Power down the cpu
 * @flags - Flags to flush cache
 *
 * This is an end point to power down cpu. If there was a pending interrupt,
 * the control would return from this function, otherwise, the cpu jumps to the
 * warm boot entry point set for this cpu upon reset.
 */
void qcom_scm_cpu_power_down(u32 flags)
{
	__qcom_scm_cpu_power_down(flags);
}
EXPORT_SYMBOL(qcom_scm_cpu_power_down);