Commit | Line | Data |
---|---|---|
1da177e4 LT |
1 | /* |
2 | * LCD Lowlevel Control Abstraction | |
3 | * | |
4 | * Copyright (C) 2003,2004 Hewlett-Packard Company | |
5 | * | |
6 | */ | |
7 | ||
8 | #ifndef _LINUX_LCD_H | |
9 | #define _LINUX_LCD_H | |
10 | ||
11 | #include <linux/device.h> | |
28ee086d | 12 | #include <linux/mutex.h> |
1da177e4 | 13 | #include <linux/notifier.h> |
faa312da | 14 | #include <linux/fb.h> |
1da177e4 | 15 | |
28ee086d RP |
16 | /* Notes on locking: |
17 | * | |
599a52d1 | 18 | * lcd_device->ops_lock is an internal backlight lock protecting the ops |
28ee086d RP |
19 | * field and no code outside the core should need to touch it. |
20 | * | |
21 | * Access to set_power() is serialised by the update_lock mutex since | |
22 | * most drivers seem to need this and historically get it wrong. | |
23 | * | |
24 | * Most drivers don't need locking on their get_power() method. | |
25 | * If yours does, you need to implement it in the driver. You can use the | |
26 | * update_lock mutex if appropriate. | |
27 | * | |
28 | * Any other use of the locks below is probably wrong. | |
29 | */ | |
30 | ||
1da177e4 LT |
31 | struct lcd_device; |
32 | struct fb_info; | |
33 | ||
1da177e4 | 34 | struct lcd_properties { |
599a52d1 RP |
35 | /* The maximum value for contrast (read-only) */ |
36 | int max_contrast; | |
37 | }; | |
38 | ||
39 | struct lcd_ops { | |
1da177e4 LT |
40 | /* Get the LCD panel power status (0: full on, 1..3: controller |
41 | power on, flat panel power off, 4: full off), see FB_BLANK_XXX */ | |
42 | int (*get_power)(struct lcd_device *); | |
d54ad83f ID |
43 | /* |
44 | * Enable or disable power to the LCD(0: on; 4: off, see FB_BLANK_XXX) | |
45 | * and this callback would be called proir to fb driver's callback. | |
46 | * | |
47 | * P.S. note that if early_set_power is not NULL then early fb notifier | |
48 | * would be registered. | |
49 | */ | |
50 | int (*early_set_power)(struct lcd_device *, int power); | |
51 | /* revert the effects of the early blank event. */ | |
52 | int (*r_early_set_power)(struct lcd_device *, int power); | |
1da177e4 LT |
53 | /* Enable or disable power to the LCD (0: on; 4: off, see FB_BLANK_XXX) */ |
54 | int (*set_power)(struct lcd_device *, int power); | |
1da177e4 LT |
55 | /* Get the current contrast setting (0-max_contrast) */ |
56 | int (*get_contrast)(struct lcd_device *); | |
57 | /* Set LCD panel contrast */ | |
58 | int (*set_contrast)(struct lcd_device *, int contrast); | |
faa312da EM |
59 | /* Set LCD panel mode (resolutions ...) */ |
60 | int (*set_mode)(struct lcd_device *, struct fb_videomode *); | |
1da177e4 LT |
61 | /* Check if given framebuffer device is the one LCD is bound to; |
62 | return 0 if not, !=0 if it is. If NULL, lcd always matches the fb. */ | |
0c531360 | 63 | int (*check_fb)(struct lcd_device *, struct fb_info *); |
1da177e4 LT |
64 | }; |
65 | ||
66 | struct lcd_device { | |
599a52d1 RP |
67 | struct lcd_properties props; |
68 | /* This protects the 'ops' field. If 'ops' is NULL, the driver that | |
1da177e4 LT |
69 | registered this device has been unloaded, and if class_get_devdata() |
70 | points to something in the body of that driver, it is also invalid. */ | |
599a52d1 | 71 | struct mutex ops_lock; |
1da177e4 | 72 | /* If this is NULL, the backing module is unloaded */ |
599a52d1 | 73 | struct lcd_ops *ops; |
28ee086d RP |
74 | /* Serialise access to set_power method */ |
75 | struct mutex update_lock; | |
1da177e4 LT |
76 | /* The framebuffer notifier block */ |
77 | struct notifier_block fb_notif; | |
655bfd7a RP |
78 | |
79 | struct device dev; | |
1da177e4 LT |
80 | }; |
81 | ||
ee378a5c ID |
82 | struct lcd_platform_data { |
83 | /* reset lcd panel device. */ | |
84 | int (*reset)(struct lcd_device *ld); | |
85 | /* on or off to lcd panel. if 'enable' is 0 then | |
86 | lcd power off and 1, lcd power on. */ | |
87 | int (*power_on)(struct lcd_device *ld, int enable); | |
88 | ||
89 | /* it indicates whether lcd panel was enabled | |
90 | from bootloader or not. */ | |
91 | int lcd_enabled; | |
92 | /* it means delay for stable time when it becomes low to high | |
93 | or high to low that is dependent on whether reset gpio is | |
94 | low active or high active. */ | |
95 | unsigned int reset_delay; | |
96 | /* stable time needing to become lcd power on. */ | |
97 | unsigned int power_on_delay; | |
98 | /* stable time needing to become lcd power off. */ | |
99 | unsigned int power_off_delay; | |
100 | ||
101 | /* it could be used for any purpose. */ | |
102 | void *pdata; | |
103 | }; | |
104 | ||
28ee086d RP |
105 | static inline void lcd_set_power(struct lcd_device *ld, int power) |
106 | { | |
107 | mutex_lock(&ld->update_lock); | |
599a52d1 RP |
108 | if (ld->ops && ld->ops->set_power) |
109 | ld->ops->set_power(ld, power); | |
28ee086d RP |
110 | mutex_unlock(&ld->update_lock); |
111 | } | |
112 | ||
1da177e4 | 113 | extern struct lcd_device *lcd_device_register(const char *name, |
655bfd7a | 114 | struct device *parent, void *devdata, struct lcd_ops *ops); |
1d0c48e6 JH |
115 | extern struct lcd_device *devm_lcd_device_register(struct device *dev, |
116 | const char *name, struct device *parent, | |
117 | void *devdata, struct lcd_ops *ops); | |
1da177e4 | 118 | extern void lcd_device_unregister(struct lcd_device *ld); |
1d0c48e6 JH |
119 | extern void devm_lcd_device_unregister(struct device *dev, |
120 | struct lcd_device *ld); | |
1da177e4 | 121 | |
655bfd7a RP |
122 | #define to_lcd_device(obj) container_of(obj, struct lcd_device, dev) |
123 | ||
124 | static inline void * lcd_get_data(struct lcd_device *ld_dev) | |
125 | { | |
126 | return dev_get_drvdata(&ld_dev->dev); | |
127 | } | |
128 | ||
1da177e4 LT |
129 | |
130 | #endif |