| 1 | * The simple eMMC hardware reset provider |
| 2 | |
| 3 | The purpose of this driver is to perform standard eMMC hw reset |
| 4 | procedure, as descibed by Jedec 4.4 specification. This procedure is |
| 5 | performed just after MMC core enabled power to the given mmc host (to |
| 6 | fix possible issues if bootloader has left eMMC card in initialized or |
| 7 | unknown state), and before performing complete system reboot (also in |
| 8 | case of emergency reboot call). The latter is needed on boards, which |
| 9 | doesn't have hardware reset logic connected to emmc card and (limited or |
| 10 | broken) ROM bootloaders are unable to read second stage from the emmc |
| 11 | card if the card is left in unknown or already initialized state. |
| 12 | |
| 13 | Required properties: |
| 14 | - compatible : contains "mmc-pwrseq-emmc". |
| 15 | - reset-gpios : contains a GPIO specifier. The reset GPIO is asserted |
| 16 | and then deasserted to perform eMMC card reset. To perform |
| 17 | reset procedure as described in Jedec 4.4 specification, the |
| 18 | gpio line should be defined as GPIO_ACTIVE_LOW. |
| 19 | |
| 20 | Example: |
| 21 | |
| 22 | sdhci0_pwrseq { |
| 23 | compatible = "mmc-pwrseq-emmc"; |
| 24 | reset-gpios = <&gpio1 12 GPIO_ACTIVE_LOW>; |
| 25 | } |