| 1 | * Maxim MAX310X advanced Universal Asynchronous Receiver-Transmitter (UART) |
| 2 | |
| 3 | Required properties: |
| 4 | - compatible: Should be one of the following: |
| 5 | - "maxim,max3107" for Maxim MAX3107, |
| 6 | - "maxim,max3108" for Maxim MAX3108, |
| 7 | - "maxim,max3109" for Maxim MAX3109, |
| 8 | - "maxim,max14830" for Maxim MAX14830. |
| 9 | - reg: SPI chip select number. |
| 10 | - interrupt-parent: The phandle for the interrupt controller that |
| 11 | services interrupts for this IC. |
| 12 | - interrupts: Specifies the interrupt source of the parent interrupt |
| 13 | controller. The format of the interrupt specifier depends on the |
| 14 | parent interrupt controller. |
| 15 | - clocks: phandle to the IC source clock. |
| 16 | - clock-names: Should be "xtal" if clock is an external crystal or |
| 17 | "osc" if an external clock source is used. |
| 18 | |
| 19 | Optional properties: |
| 20 | - gpio-controller: Marks the device node as a GPIO controller. |
| 21 | - #gpio-cells: Should be two. The first cell is the GPIO number and |
| 22 | the second cell is used to specify the GPIO polarity: |
| 23 | 0 = active high, |
| 24 | 1 = active low. |
| 25 | |
| 26 | Example: |
| 27 | max14830: max14830@0 { |
| 28 | compatible = "maxim,max14830"; |
| 29 | reg = <0>; |
| 30 | clocks = <&clk20m>; |
| 31 | clock-names = "osc"; |
| 32 | interrupt-parent = <&gpio3>; |
| 33 | interrupts = <7 IRQ_TYPE_EDGE_FALLING>; |
| 34 | gpio-controller; |
| 35 | #gpio-cells = <2>; |
| 36 | }; |