1 Qualcomm SPMI Regulators
6 Definition: must be one of:
7 "qcom,pm8841-regulators"
8 "qcom,pm8916-regulators"
9 "qcom,pm8941-regulators"
13 Value type: <prop-encoded-array>
14 Definition: List of OCP interrupts.
17 Usage: required if 'interrupts' property present
18 Value type: <string-array>
19 Definition: List of strings defining the names of the
20 interrupts in the 'interrupts' property 1-to-1.
21 Supported values are "ocp-<regulator_name>", where
22 <regulator_name> corresponds to a voltage switch
33 Usage: optional (pm8841 only)
35 Definition: Reference to regulator supplying the input pin, as
36 described in the data sheet.
44 - vdd_l4_l5_l6-supply:
46 - vdd_l8_l11_l14_l15_l16-supply:
47 - vdd_l9_l10_l12_l13_l17_l18-supply:
48 Usage: optional (pm8916 only)
50 Definition: Reference to regulator supplying the input pin, as
51 described in the data sheet.
57 - vdd_l2_lvs_1_2_3-supply:
60 - vdd_l6_l12_l14_l15-supply:
61 - vdd_l8_l16_l18_19-supply:
62 - vdd_l9_l10_l17_l22-supply:
63 - vdd_l13_l20_l23_l24-supply:
66 Usage: optional (pm8941 only)
68 Definition: Reference to regulator supplying the input pin, as
69 described in the data sheet.
72 The regulator node houses sub-nodes for each regulator within the device. Each
73 sub-node is identified using the node's name, with valid values listed for each
77 s1, s2, s3, s4, s5, s6, s7, s8
80 s1, s2, s3, s4, l1, l2, l3, l4, l5, l6, l7, l8, l9, l10, l11, l12, l13,
81 l14, l15, l16, l17, l18
84 s1, s2, s3, l1, l2, l3, l4, l5, l6, l7, l8, l9, l10, l11, l12, l13, l14,
85 l15, l16, l17, l18, l19, l20, l21, l22, l23, l24, lvs1, lvs2, lvs3,
88 The content of each sub-node is defined by the standard binding for regulators -
89 see regulator.txt - with additional custom properties described below:
91 - regulator-initial-mode:
94 Descrption: 1 = Set initial mode to high power mode (HPM), also referred
95 to as NPM. HPM consumes more ground current than LPM, but
96 it can source significantly higher load current. HPM is not
97 available on boost type regulators. For voltage switch type
98 regulators, HPM implies that over current protection and
99 soft start are active all the time. 0 = Set initial mode to
100 low power mode (LPM).
105 compatible = "qcom,pm8941-regulators";
106 vdd_l1_l3-supply = <&s1>;
109 regulator-min-microvolt = <1300000>;
110 regulator-max-microvolt = <1400000>;
116 regulator-min-microvolt = <1225000>;
117 regulator-max-microvolt = <1300000>;