arch/arm/Kconfig-nommu

   1 #
   2 # Kconfig for uClinux(non-paged MM) depend configurations
   3 # Hyok S. Choi <hyok.choi@samsung.com>
   4 #
   5
   6 config SET_MEM_PARAM
   7         bool "Set flash/sdram size and base addr"
   8         help
   9          Say Y to manually set the base addresses and sizes.
  10          otherwise, the default values are assigned.
  11
  12 config DRAM_BASE
  13         hex '(S)DRAM Base Address' if SET_MEM_PARAM
  14         default 0x00800000
  15
  16 config DRAM_SIZE
  17         hex '(S)DRAM SIZE' if SET_MEM_PARAM
  18         default 0x00800000
  19
  20 config FLASH_MEM_BASE
  21         hex 'FLASH Base Address' if SET_MEM_PARAM
  22         default 0x00400000
  23
  24 config FLASH_SIZE
  25         hex 'FLASH Size' if SET_MEM_PARAM
  26         default 0x00400000
  27
  28 config PROCESSOR_ID
  29         hex 'Hard wire the processor ID'
  30         default 0x00007700
  31         depends on !CPU_CP15
  32         help
  33           If processor has no CP15 register, this processor ID is
  34           used instead of the auto-probing which utilizes the register.
  35
  36 config REMAP_VECTORS_TO_RAM
  37         bool 'Install vectors to the beginning of RAM' if DRAM_BASE
  38         depends on DRAM_BASE
  39         help
  40           The kernel needs to change the hardware exception vectors.
  41           In nommu mode, the hardware exception vectors are normally
  42           placed at address 0x00000000. However, this region may be
  43           occupied by read-only memory depending on H/W design.
  44
  45           If the region contains read-write memory, say 'n' here.
  46
  47           If your CPU provides a remap facility which allows the exception
  48           vectors to be mapped to writable memory, say 'n' here.
  49
  50           Otherwise, say 'y' here.  In this case, the kernel will require
  51           external support to redirect the hardware exception vectors to
  52           the writable versions located at DRAM_BASE.