arch/arm/mach-at91/board-csb637.c

   1 /*
   2  * linux/arch/arm/mach-at91/board-csb637.c
   3  *
   4  *  Copyright (C) 2005 SAN People
   5  *
   6  * This program is free software; you can redistribute it and/or modify
   7  * it under the terms of the GNU General Public License as published by
   8  * the Free Software Foundation; either version 2 of the License, or
   9  * (at your option) any later version.
  10  *
  11  * This program is distributed in the hope that it will be useful,
  12  * but WITHOUT ANY WARRANTY; without even the implied warranty of
  13  * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the
  14  * GNU General Public License for more details.
  15  *
  16  * You should have received a copy of the GNU General Public License
  17  * along with this program; if not, write to the Free Software
  18  * Foundation, Inc., 59 Temple Place, Suite 330, Boston, MA  02111-1307  USA
  19  */
  20
  21 #include <linux/types.h>
  22 #include <linux/init.h>
  23 #include <linux/gpio.h>
  24 #include <linux/mm.h>
  25 #include <linux/module.h>
  26 #include <linux/platform_device.h>
  27 #include <linux/mtd/physmap.h>
  28
  29 #include <asm/setup.h>
  30 #include <asm/mach-types.h>
  31 #include <asm/irq.h>
  32
  33 #include <asm/mach/arch.h>
  34 #include <asm/mach/map.h>
  35 #include <asm/mach/irq.h>
  36
  37 #include <mach/hardware.h>
  38 #include <mach/board.h>
  39
  40 #include "generic.h"
  41
  42
  43 static void __init csb637_init_early(void)
  44 {
  45         /* Initialize processor: 3.6864 MHz crystal */
  46         at91_initialize(3686400);
  47 }
  48
  49 static struct macb_platform_data __initdata csb637_eth_data = {
  50         .phy_irq_pin    = AT91_PIN_PC0,
  51         .is_rmii        = 0,
  52 };
  53
  54 static struct at91_usbh_data __initdata csb637_usbh_data = {
  55         .ports          = 2,
  56         .vbus_pin       = {-EINVAL, -EINVAL},
  57         .overcurrent_pin= {-EINVAL, -EINVAL},
  58 };
  59
  60 static struct at91_udc_data __initdata csb637_udc_data = {
  61         .vbus_pin     = AT91_PIN_PB28,
  62         .pullup_pin   = AT91_PIN_PB1,
  63 };
  64
  65 #define CSB_FLASH_BASE  AT91_CHIPSELECT_0
  66 #define CSB_FLASH_SIZE  SZ_16M
  67
  68 static struct mtd_partition csb_flash_partitions[] = {
  69         {
  70                 .name           = "uMON flash",
  71                 .offset         = 0,
  72                 .size           = MTDPART_SIZ_FULL,
  73                 .mask_flags     = MTD_WRITEABLE,        /* read only */
  74         }
  75 };
  76
  77 static struct physmap_flash_data csb_flash_data = {
  78         .width          = 2,
  79         .parts          = csb_flash_partitions,
  80         .nr_parts       = ARRAY_SIZE(csb_flash_partitions),
  81 };
  82
  83 static struct resource csb_flash_resources[] = {
  84         {
  85                 .start  = CSB_FLASH_BASE,
  86                 .end    = CSB_FLASH_BASE + CSB_FLASH_SIZE - 1,
  87                 .flags  = IORESOURCE_MEM,
  88         }
  89 };
  90
  91 static struct platform_device csb_flash = {
  92         .name           = "physmap-flash",
  93         .id             = 0,
  94         .dev            = {
  95                                 .platform_data = &csb_flash_data,
  96                         },
  97         .resource       = csb_flash_resources,
  98         .num_resources  = ARRAY_SIZE(csb_flash_resources),
  99 };
 100
 101 static struct gpio_led csb_leds[] = {
 102         {       /* "d1", red */
 103                 .name                   = "d1",
 104                 .gpio                   = AT91_PIN_PB2,
 105                 .active_low             = 1,
 106                 .default_trigger        = "heartbeat",
 107         },
 108 };
 109
 110 static void __init csb637_board_init(void)
 111 {
 112         /* LED(s) */
 113         at91_gpio_leds(csb_leds, ARRAY_SIZE(csb_leds));
 114         /* Serial */
 115         /* DBGU on ttyS0. (Rx & Tx only) */
 116         at91_register_uart(0, 0, 0);
 117         at91_add_device_serial();
 118         /* Ethernet */
 119         at91_add_device_eth(&csb637_eth_data);
 120         /* USB Host */
 121         at91_add_device_usbh(&csb637_usbh_data);
 122         /* USB Device */
 123         at91_add_device_udc(&csb637_udc_data);
 124         /* I2C */
 125         at91_add_device_i2c(NULL, 0);
 126         /* SPI */
 127         at91_add_device_spi(NULL, 0);
 128         /* NOR flash */
 129         platform_device_register(&csb_flash);
 130 }
 131
 132 MACHINE_START(CSB637, "Cogent CSB637")
 133         /* Maintainer: Bill Gatliff */
 134         .timer          = &at91rm9200_timer,
 135         .map_io         = at91_map_io,
 136         .init_early     = csb637_init_early,
 137         .init_irq       = at91_init_irq_default,
 138         .init_machine   = csb637_board_init,
 139 MACHINE_END