drm/i915: constify harder
[deliverable/linux.git] / arch / unicore32 / Kconfig
1 config UNICORE32
2 def_bool y
3 select HAVE_MEMBLOCK
4 select HAVE_GENERIC_DMA_COHERENT
5 select HAVE_DMA_ATTRS
6 select HAVE_KERNEL_GZIP
7 select HAVE_KERNEL_BZIP2
8 select GENERIC_ATOMIC64
9 select HAVE_KERNEL_LZO
10 select HAVE_KERNEL_LZMA
11 select VIRT_TO_BUS
12 select ARCH_HAVE_CUSTOM_GPIO_H
13 select GENERIC_FIND_FIRST_BIT
14 select GENERIC_IRQ_PROBE
15 select GENERIC_IRQ_SHOW
16 select ARCH_WANT_FRAME_POINTERS
17 select GENERIC_IOMAP
18 select MODULES_USE_ELF_REL
19 help
20 UniCore-32 is 32-bit Instruction Set Architecture,
21 including a series of low-power-consumption RISC chip
22 designs licensed by PKUnity Ltd.
23 Please see web page at <http://www.pkunity.com/>.
24
25 config GENERIC_CSUM
26 def_bool y
27
28 config NO_IOPORT
29 bool
30
31 config STACKTRACE_SUPPORT
32 def_bool y
33
34 config HAVE_LATENCYTOP_SUPPORT
35 def_bool y
36
37 config LOCKDEP_SUPPORT
38 def_bool y
39
40 config RWSEM_GENERIC_SPINLOCK
41 def_bool y
42
43 config RWSEM_XCHGADD_ALGORITHM
44 bool
45
46 config ARCH_HAS_ILOG2_U32
47 bool
48
49 config ARCH_HAS_ILOG2_U64
50 bool
51
52 config ARCH_HAS_CPUFREQ
53 bool
54
55 config GENERIC_HWEIGHT
56 def_bool y
57
58 config GENERIC_CALIBRATE_DELAY
59 def_bool y
60
61 config ARCH_MAY_HAVE_PC_FDC
62 bool
63
64 config ZONE_DMA
65 def_bool y
66
67 config NEED_DMA_MAP_STATE
68 def_bool y
69
70 source "init/Kconfig"
71
72 source "kernel/Kconfig.freezer"
73
74 menu "System Type"
75
76 config MMU
77 def_bool y
78
79 config ARCH_FPGA
80 bool
81
82 config ARCH_PUV3
83 def_bool y
84 select CPU_UCV2
85 select GENERIC_CLOCKEVENTS
86 select HAVE_CLK
87 select ARCH_REQUIRE_GPIOLIB
88 select ARCH_HAS_CPUFREQ
89
90 # CONFIGs for ARCH_PUV3
91
92 if ARCH_PUV3
93
94 choice
95 prompt "Board Selection"
96 default PUV3_DB0913
97
98 config PUV3_FPGA_DLX200
99 select ARCH_FPGA
100 bool "FPGA board"
101
102 config PUV3_DB0913
103 bool "DEBUG board (0913)"
104
105 config PUV3_NB0916
106 bool "NetBook board (0916)"
107 select PWM
108 select PWM_PUV3
109
110 config PUV3_SMW0919
111 bool "Security Mini-Workstation board (0919)"
112
113 endchoice
114
115 config PUV3_PM
116 def_bool y if !ARCH_FPGA
117
118 endif
119
120 source "arch/unicore32/mm/Kconfig"
121
122 comment "Floating poing support"
123
124 config UNICORE_FPU_F64
125 def_bool y if !ARCH_FPGA
126
127 endmenu
128
129 menu "Bus support"
130
131 config PCI
132 bool "PCI Support"
133 help
134 Find out whether you have a PCI motherboard. PCI is the name of a
135 bus system, i.e. the way the CPU talks to the other stuff inside
136 your box. Other bus systems are ISA, EISA, MicroChannel (MCA) or
137 VESA. If you have PCI, say Y, otherwise N.
138
139 source "drivers/pci/Kconfig"
140
141 source "drivers/pcmcia/Kconfig"
142
143 endmenu
144
145 menu "Kernel Features"
146
147 source "kernel/Kconfig.preempt"
148
149 source "kernel/Kconfig.hz"
150
151 source "mm/Kconfig"
152
153 config LEDS
154 def_bool y
155 depends on GPIOLIB
156
157 config ALIGNMENT_TRAP
158 def_bool y
159 help
160 Unicore processors can not fetch/store information which is not
161 naturally aligned on the bus, i.e., a 4 byte fetch must start at an
162 address divisible by 4. On 32-bit Unicore processors, these non-aligned
163 fetch/store instructions will be emulated in software if you say
164 here, which has a severe performance impact. This is necessary for
165 correct operation of some network protocols. With an IP-only
166 configuration it is safe to say N, otherwise say Y.
167
168 endmenu
169
170 menu "Boot options"
171
172 config CMDLINE
173 string "Default kernel command string"
174 default ""
175
176 config CMDLINE_FORCE
177 bool "Always use the default kernel command string"
178 depends on CMDLINE != ""
179 help
180 Always use the default kernel command string, even if the boot
181 loader passes other arguments to the kernel.
182 This is useful if you cannot or don't want to change the
183 command-line options your boot loader passes to the kernel.
184
185 If unsure, say N.
186
187 endmenu
188
189 menu "Userspace binary formats"
190
191 source "fs/Kconfig.binfmt"
192
193 endmenu
194
195 menu "Power management options"
196
197 source "kernel/power/Kconfig"
198
199 if ARCH_HAS_CPUFREQ
200 source "drivers/cpufreq/Kconfig"
201 endif
202
203 config ARCH_SUSPEND_POSSIBLE
204 def_bool y if !ARCH_FPGA
205
206 config ARCH_HIBERNATION_POSSIBLE
207 def_bool y if !ARCH_FPGA
208
209 endmenu
210
211 source "net/Kconfig"
212
213 if ARCH_PUV3
214
215 config PUV3_GPIO
216 bool
217 depends on !ARCH_FPGA
218 select GPIO_SYSFS
219 default y
220
221 if PUV3_NB0916
222
223 menu "PKUnity NetBook-0916 Features"
224
225 config I2C_BATTERY_BQ27200
226 tristate "I2C Battery BQ27200 Support"
227 select I2C_PUV3
228 select POWER_SUPPLY
229 select BATTERY_BQ27x00
230
231 config I2C_EEPROM_AT24
232 tristate "I2C EEPROMs AT24 support"
233 select I2C_PUV3
234 select EEPROM_AT24
235
236 config LCD_BACKLIGHT
237 tristate "LCD Backlight support"
238 select BACKLIGHT_LCD_SUPPORT
239 select BACKLIGHT_PWM
240
241 endmenu
242
243 endif
244
245 endif
246
247 source "drivers/Kconfig"
248
249 source "fs/Kconfig"
250
251 source "arch/unicore32/Kconfig.debug"
252
253 source "security/Kconfig"
254
255 source "crypto/Kconfig"
256
257 source "lib/Kconfig"
This page took 0.036172 seconds and 5 git commands to generate.