arch/x86/boot/compressed/head_32.S

   1 /*
   2  *  linux/boot/head.S
   3  *
   4  *  Copyright (C) 1991, 1992, 1993  Linus Torvalds
   5  */
   6
   7 /*
   8  *  head.S contains the 32-bit startup code.
   9  *
  10  * NOTE!!! Startup happens at absolute address 0x00001000, which is also where
  11  * the page directory will exist. The startup code will be overwritten by
  12  * the page directory. [According to comments etc elsewhere on a compressed
  13  * kernel it will end up at 0x1000 + 1Mb I hope so as I assume this. - AC]
  14  *
  15  * Page 0 is deliberately kept safe, since System Management Mode code in
  16  * laptops may need to access the BIOS data stored there.  This is also
  17  * useful for future device drivers that either access the BIOS via VM86
  18  * mode.
  19  */
  20
  21 /*
  22  * High loaded stuff by Hans Lermen & Werner Almesberger, Feb. 1996
  23  */
  24         .text
  25
  26 #include <linux/init.h>
  27 #include <linux/linkage.h>
  28 #include <asm/segment.h>
  29 #include <asm/page_types.h>
  30 #include <asm/boot.h>
  31 #include <asm/asm-offsets.h>
  32 #include <asm/bootparam.h>
  33
  34 /*
  35  * The 32-bit x86 assembler in binutils 2.26 will generate R_386_GOT32X
  36  * relocation to get the symbol address in PIC.  When the compressed x86
  37  * kernel isn't built as PIC, the linker optimizes R_386_GOT32X
  38  * relocations to their fixed symbol addresses.  However, when the
  39  * compressed x86 kernel is loaded at a different address, it leads
  40  * to the following load failure:
  41  *
  42  *   Failed to allocate space for phdrs
  43  *
  44  * during the decompression stage.
  45  *
  46  * If the compressed x86 kernel is relocatable at run-time, it should be
  47  * compiled with -fPIE, instead of -fPIC, if possible and should be built as
  48  * Position Independent Executable (PIE) so that linker won't optimize
  49  * R_386_GOT32X relocation to its fixed symbol address.  Older
  50  * linkers generate R_386_32 relocations against locally defined symbols,
  51  * _bss, _ebss, _got and _egot, in PIE.  It isn't wrong, just less
  52  * optimal than R_386_RELATIVE.  But the x86 kernel fails to properly handle
  53  * R_386_32 relocations when relocating the kernel.  To generate
  54  * R_386_RELATIVE relocations, we mark _bss, _ebss, _got and _egot as
  55  * hidden:
  56  */
  57         .hidden _bss
  58         .hidden _ebss
  59         .hidden _got
  60         .hidden _egot
  61
  62         __HEAD
  63 ENTRY(startup_32)
  64 #ifdef CONFIG_EFI_STUB
  65         jmp     preferred_addr
  66
  67         /*
  68          * We don't need the return address, so set up the stack so
  69          * efi_main() can find its arguments.
  70          */
  71 ENTRY(efi_pe_entry)
  72         add     $0x4, %esp
  73
  74         call    1f
  75 1:      popl    %esi
  76         subl    $1b, %esi
  77
  78         popl    %ecx
  79         movl    %ecx, efi32_config(%esi)        /* Handle */
  80         popl    %ecx
  81         movl    %ecx, efi32_config+8(%esi)      /* EFI System table pointer */
  82
  83         /* Relocate efi_config->call() */
  84         leal    efi32_config(%esi), %eax
  85         add     %esi, 88(%eax)
  86         pushl   %eax
  87
  88         call    make_boot_params
  89         cmpl    $0, %eax
  90         je      fail
  91         movl    %esi, BP_code32_start(%eax)
  92         popl    %ecx
  93         pushl   %eax
  94         pushl   %ecx
  95         jmp     2f              /* Skip efi_config initialization */
  96
  97 ENTRY(efi32_stub_entry)
  98         add     $0x4, %esp
  99         popl    %ecx
 100         popl    %edx
 101
 102         call    1f
 103 1:      popl    %esi
 104         subl    $1b, %esi
 105
 106         movl    %ecx, efi32_config(%esi)        /* Handle */
 107         movl    %edx, efi32_config+8(%esi)      /* EFI System table pointer */
 108
 109         /* Relocate efi_config->call() */
 110         leal    efi32_config(%esi), %eax
 111         add     %esi, 88(%eax)
 112         pushl   %eax
 113 2:
 114         call    efi_main
 115         cmpl    $0, %eax
 116         movl    %eax, %esi
 117         jne     2f
 118 fail:
 119         /* EFI init failed, so hang. */
 120         hlt
 121         jmp     fail
 122 2:
 123         movl    BP_code32_start(%esi), %eax
 124         leal    preferred_addr(%eax), %eax
 125         jmp     *%eax
 126
 127 preferred_addr:
 128 #endif
 129         cld
 130         /*
 131          * Test KEEP_SEGMENTS flag to see if the bootloader is asking
 132          * us to not reload segments
 133          */
 134         testb   $KEEP_SEGMENTS, BP_loadflags(%esi)
 135         jnz     1f
 136
 137         cli
 138         movl    $__BOOT_DS, %eax
 139         movl    %eax, %ds
 140         movl    %eax, %es
 141         movl    %eax, %fs
 142         movl    %eax, %gs
 143         movl    %eax, %ss
 144 1:
 145
 146 /*
 147  * Calculate the delta between where we were compiled to run
 148  * at and where we were actually loaded at.  This can only be done
 149  * with a short local call on x86.  Nothing  else will tell us what
 150  * address we are running at.  The reserved chunk of the real-mode
 151  * data at 0x1e4 (defined as a scratch field) are used as the stack
 152  * for this calculation. Only 4 bytes are needed.
 153  */
 154         leal    (BP_scratch+4)(%esi), %esp
 155         call    1f
 156 1:      popl    %ebp
 157         subl    $1b, %ebp
 158
 159 /*
 160  * %ebp contains the address we are loaded at by the boot loader and %ebx
 161  * contains the address where we should move the kernel image temporarily
 162  * for safe in-place decompression.
 163  */
 164
 165 #ifdef CONFIG_RELOCATABLE
 166         movl    %ebp, %ebx
 167         movl    BP_kernel_alignment(%esi), %eax
 168         decl    %eax
 169         addl    %eax, %ebx
 170         notl    %eax
 171         andl    %eax, %ebx
 172         cmpl    $LOAD_PHYSICAL_ADDR, %ebx
 173         jge     1f
 174 #endif
 175         movl    $LOAD_PHYSICAL_ADDR, %ebx
 176 1:
 177
 178         /* Target address to relocate to for decompression */
 179         movl    BP_init_size(%esi), %eax
 180         subl    $_end, %eax
 181         addl    %eax, %ebx
 182
 183         /* Set up the stack */
 184         leal    boot_stack_end(%ebx), %esp
 185
 186         /* Zero EFLAGS */
 187         pushl   $0
 188         popfl
 189
 190 /*
 191  * Copy the compressed kernel to the end of our buffer
 192  * where decompression in place becomes safe.
 193  */
 194         pushl   %esi
 195         leal    (_bss-4)(%ebp), %esi
 196         leal    (_bss-4)(%ebx), %edi
 197         movl    $(_bss - startup_32), %ecx
 198         shrl    $2, %ecx
 199         std
 200         rep     movsl
 201         cld
 202         popl    %esi
 203
 204 /*
 205  * Jump to the relocated address.
 206  */
 207         leal    relocated(%ebx), %eax
 208         jmp     *%eax
 209 ENDPROC(startup_32)
 210
 211         .text
 212 relocated:
 213
 214 /*
 215  * Clear BSS (stack is currently empty)
 216  */
 217         xorl    %eax, %eax
 218         leal    _bss(%ebx), %edi
 219         leal    _ebss(%ebx), %ecx
 220         subl    %edi, %ecx
 221         shrl    $2, %ecx
 222         rep     stosl
 223
 224 /*
 225  * Adjust our own GOT
 226  */
 227         leal    _got(%ebx), %edx
 228         leal    _egot(%ebx), %ecx
 229 1:
 230         cmpl    %ecx, %edx
 231         jae     2f
 232         addl    %ebx, (%edx)
 233         addl    $4, %edx
 234         jmp     1b
 235 2:
 236
 237 /*
 238  * Do the extraction, and jump to the new kernel..
 239  */
 240                                 /* push arguments for extract_kernel: */
 241         pushl   $z_output_len   /* decompressed length, end of relocs */
 242
 243         movl    BP_init_size(%esi), %eax
 244         subl    $_end, %eax
 245         movl    %ebx, %ebp
 246         subl    %eax, %ebp
 247         pushl   %ebp            /* output address */
 248
 249         pushl   $z_input_len    /* input_len */
 250         leal    input_data(%ebx), %eax
 251         pushl   %eax            /* input_data */
 252         leal    boot_heap(%ebx), %eax
 253         pushl   %eax            /* heap area */
 254         pushl   %esi            /* real mode pointer */
 255         call    extract_kernel  /* returns kernel location in %eax */
 256         addl    $24, %esp
 257
 258 /*
 259  * Jump to the extracted kernel.
 260  */
 261         xorl    %ebx, %ebx
 262         jmp     *%eax
 263
 264 #ifdef CONFIG_EFI_STUB
 265         .data
 266 efi32_config:
 267         .fill 11,8,0
 268         .long efi_call_phys
 269         .long 0
 270         .byte 0
 271 #endif
 272
 273 /*
 274  * Stack and heap for uncompression
 275  */
 276         .bss
 277         .balign 4
 278 boot_heap:
 279         .fill BOOT_HEAP_SIZE, 1, 0
 280 boot_stack:
 281         .fill BOOT_STACK_SIZE, 1, 0
 282 boot_stack_end: