1 /******************************************************************************
4 * Generic x86 (32-bit and 64-bit) instruction decoder and emulator.
6 * Copyright (c) 2005 Keir Fraser
8 * From: xen-unstable 10676:af9809f51f81a3c43f276f00c81a52ef558afda4
11 #ifndef _ASM_X86_KVM_X86_EMULATE_H
12 #define _ASM_X86_KVM_X86_EMULATE_H
14 struct x86_emulate_ctxt
;
19 * These operations represent the instruction emulator's interface to memory.
20 * There are two categories of operation: those that act on ordinary memory
21 * regions (*_std), and those that act on memory regions known to require
22 * special treatment or emulation (*_emulated).
24 * The emulator assumes that an instruction accesses only one 'emulated memory'
25 * location, that this location is the given linear faulting address (cr2), and
26 * that this is one of the instruction's data operands. Instruction fetches and
27 * stack operations are assumed never to access emulated memory. The emulator
28 * automatically deduces which operand of a string-move operation is accessing
29 * emulated memory, and assumes that the other operand accesses normal memory.
32 * 1. The emulator isn't very smart about emulated vs. standard memory.
33 * 'Emulated memory' access addresses should be checked for sanity.
34 * 'Normal memory' accesses may fault, and the caller must arrange to
35 * detect and handle reentrancy into the emulator via recursive faults.
36 * Accesses may be unaligned and may cross page boundaries.
37 * 2. If the access fails (cannot emulate, or a standard access faults) then
38 * it is up to the memop to propagate the fault to the guest VM via
39 * some out-of-band mechanism, unknown to the emulator. The memop signals
40 * failure by returning X86EMUL_PROPAGATE_FAULT to the emulator, which will
41 * then immediately bail.
42 * 3. Valid access sizes are 1, 2, 4 and 8 bytes. On x86/32 systems only
43 * cmpxchg8b_emulated need support 8-byte accesses.
44 * 4. The emulator cannot handle 64-bit mode emulation on an x86/32 system.
46 /* Access completed successfully: continue emulation as normal. */
47 #define X86EMUL_CONTINUE 0
48 /* Access is unhandleable: bail from emulation and return error to caller. */
49 #define X86EMUL_UNHANDLEABLE 1
50 /* Terminate emulation but return success to the caller. */
51 #define X86EMUL_PROPAGATE_FAULT 2 /* propagate a generated fault to guest */
52 #define X86EMUL_RETRY_INSTR 2 /* retry the instruction for some reason */
53 #define X86EMUL_CMPXCHG_FAILED 2 /* cmpxchg did not see expected value */
54 struct x86_emulate_ops
{
56 * read_std: Read bytes of standard (non-emulated/special) memory.
57 * Used for descriptor reading.
58 * @addr: [IN ] Linear address from which to read.
59 * @val: [OUT] Value read from memory, zero-extended to 'u_long'.
60 * @bytes: [IN ] Number of bytes to read from memory.
62 int (*read_std
)(unsigned long addr
, void *val
,
63 unsigned int bytes
, struct kvm_vcpu
*vcpu
, u32
*error
);
66 * fetch: Read bytes of standard (non-emulated/special) memory.
67 * Used for instruction fetch.
68 * @addr: [IN ] Linear address from which to read.
69 * @val: [OUT] Value read from memory, zero-extended to 'u_long'.
70 * @bytes: [IN ] Number of bytes to read from memory.
72 int (*fetch
)(unsigned long addr
, void *val
,
73 unsigned int bytes
, struct kvm_vcpu
*vcpu
, u32
*error
);
76 * read_emulated: Read bytes from emulated/special memory area.
77 * @addr: [IN ] Linear address from which to read.
78 * @val: [OUT] Value read from memory, zero-extended to 'u_long'.
79 * @bytes: [IN ] Number of bytes to read from memory.
81 int (*read_emulated
)(unsigned long addr
,
84 struct kvm_vcpu
*vcpu
);
87 * write_emulated: Write bytes to emulated/special memory area.
88 * @addr: [IN ] Linear address to which to write.
89 * @val: [IN ] Value to write to memory (low-order bytes used as
91 * @bytes: [IN ] Number of bytes to write to memory.
93 int (*write_emulated
)(unsigned long addr
,
96 struct kvm_vcpu
*vcpu
);
99 * cmpxchg_emulated: Emulate an atomic (LOCKed) CMPXCHG operation on an
100 * emulated/special memory area.
101 * @addr: [IN ] Linear address to access.
102 * @old: [IN ] Value expected to be current at @addr.
103 * @new: [IN ] Value to write to @addr.
104 * @bytes: [IN ] Number of bytes to access using CMPXCHG.
106 int (*cmpxchg_emulated
)(unsigned long addr
,
110 struct kvm_vcpu
*vcpu
);
114 /* Type, address-of, and value of an instruction's operand. */
116 enum { OP_REG
, OP_MEM
, OP_IMM
, OP_NONE
} type
;
118 unsigned long val
, orig_val
, *ptr
;
127 struct decode_cache
{
138 bool has_seg_override
;
141 unsigned long regs
[NR_VCPU_REGS
];
142 unsigned long eip
, eip_orig
;
150 unsigned long modrm_ea
;
152 unsigned long modrm_val
;
153 struct fetch_cache fetch
;
156 #define X86_SHADOW_INT_MOV_SS 1
157 #define X86_SHADOW_INT_STI 2
159 struct x86_emulate_ctxt
{
160 /* Register state before/after emulation. */
161 struct kvm_vcpu
*vcpu
;
163 unsigned long eflags
;
164 /* Emulated execution mode, represented by an X86EMUL_MODE value. */
168 /* interruptibility state, as a result of execution of STI or MOV SS */
169 int interruptibility
;
172 struct decode_cache decode
;
175 /* Repeat String Operation Prefix */
176 #define REPE_PREFIX 1
177 #define REPNE_PREFIX 2
179 /* Execution mode, passed to the emulator. */
180 #define X86EMUL_MODE_REAL 0 /* Real mode. */
181 #define X86EMUL_MODE_VM86 1 /* Virtual 8086 mode. */
182 #define X86EMUL_MODE_PROT16 2 /* 16-bit protected mode. */
183 #define X86EMUL_MODE_PROT32 4 /* 32-bit protected mode. */
184 #define X86EMUL_MODE_PROT64 8 /* 64-bit (long) mode. */
186 /* Host execution mode. */
187 #if defined(CONFIG_X86_32)
188 #define X86EMUL_MODE_HOST X86EMUL_MODE_PROT32
189 #elif defined(CONFIG_X86_64)
190 #define X86EMUL_MODE_HOST X86EMUL_MODE_PROT64
193 int x86_decode_insn(struct x86_emulate_ctxt
*ctxt
,
194 struct x86_emulate_ops
*ops
);
195 int x86_emulate_insn(struct x86_emulate_ctxt
*ctxt
,
196 struct x86_emulate_ops
*ops
);
198 #endif /* _ASM_X86_KVM_X86_EMULATE_H */
This page took 0.043403 seconds and 6 git commands to generate.