arch/x86/kernel/tsc_sync.c

   1 /*
   2  * check TSC synchronization.
   3  *
   4  * Copyright (C) 2006, Red Hat, Inc., Ingo Molnar
   5  *
   6  * We check whether all boot CPUs have their TSC's synchronized,
   7  * print a warning if not and turn off the TSC clock-source.
   8  *
   9  * The warp-check is point-to-point between two CPUs, the CPU
  10  * initiating the bootup is the 'source CPU', the freshly booting
  11  * CPU is the 'target CPU'.
  12  *
  13  * Only two CPUs may participate - they can enter in any order.
  14  * ( The serial nature of the boot logic and the CPU hotplug lock
  15  *   protects against more than 2 CPUs entering this code. )
  16  */
  17 #include <linux/spinlock.h>
  18 #include <linux/kernel.h>
  19 #include <linux/init.h>
  20 #include <linux/smp.h>
  21 #include <linux/nmi.h>
  22 #include <asm/tsc.h>
  23
  24 /*
  25  * Entry/exit counters that make sure that both CPUs
  26  * run the measurement code at once:
  27  */
  28 static __cpuinitdata atomic_t start_count;
  29 static __cpuinitdata atomic_t stop_count;
  30
  31 /*
  32  * We use a raw spinlock in this exceptional case, because
  33  * we want to have the fastest, inlined, non-debug version
  34  * of a critical section, to be able to prove TSC time-warps:
  35  */
  36 static __cpuinitdata raw_spinlock_t sync_lock = __RAW_SPIN_LOCK_UNLOCKED;
  37 static __cpuinitdata cycles_t last_tsc;
  38 static __cpuinitdata cycles_t max_warp;
  39 static __cpuinitdata int nr_warps;
  40
  41 /*
  42  * TSC-warp measurement loop running on both CPUs:
  43  */
  44 static __cpuinit void check_tsc_warp(void)
  45 {
  46         cycles_t start, now, prev, end;
  47         int i;
  48
  49         rdtsc_barrier();
  50         start = get_cycles();
  51         rdtsc_barrier();
  52         /*
  53          * The measurement runs for 20 msecs:
  54          */
  55         end = start + tsc_khz * 20ULL;
  56         now = start;
  57
  58         for (i = 0; ; i++) {
  59                 /*
  60                  * We take the global lock, measure TSC, save the
  61                  * previous TSC that was measured (possibly on
  62                  * another CPU) and update the previous TSC timestamp.
  63                  */
  64                 __raw_spin_lock(&sync_lock);
  65                 prev = last_tsc;
  66                 rdtsc_barrier();
  67                 now = get_cycles();
  68                 rdtsc_barrier();
  69                 last_tsc = now;
  70                 __raw_spin_unlock(&sync_lock);
  71
  72                 /*
  73                  * Be nice every now and then (and also check whether
  74                  * measurement is done [we also insert a 10 million
  75                  * loops safety exit, so we dont lock up in case the
  76                  * TSC readout is totally broken]):
  77                  */
  78                 if (unlikely(!(i & 7))) {
  79                         if (now > end || i > 10000000)
  80                                 break;
  81                         cpu_relax();
  82                         touch_nmi_watchdog();
  83                 }
  84                 /*
  85                  * Outside the critical section we can now see whether
  86                  * we saw a time-warp of the TSC going backwards:
  87                  */
  88                 if (unlikely(prev > now)) {
  89                         __raw_spin_lock(&sync_lock);
  90                         max_warp = max(max_warp, prev - now);
  91                         nr_warps++;
  92                         __raw_spin_unlock(&sync_lock);
  93                 }
  94         }
  95         WARN(!(now-start),
  96                 "Warning: zero tsc calibration delta: %Ld [max: %Ld]\n",
  97                         now-start, end-start);
  98 }
  99
 100 /*
 101  * Source CPU calls into this - it waits for the freshly booted
 102  * target CPU to arrive and then starts the measurement:
 103  */
 104 void __cpuinit check_tsc_sync_source(int cpu)
 105 {
 106         int cpus = 2;
 107
 108         /*
 109          * No need to check if we already know that the TSC is not
 110          * synchronized:
 111          */
 112         if (unsynchronized_tsc())
 113                 return;
 114
 115         printk(KERN_INFO "checking TSC synchronization [CPU#%d -> CPU#%d]:",
 116                           smp_processor_id(), cpu);
 117
 118         /*
 119          * Reset it - in case this is a second bootup:
 120          */
 121         atomic_set(&stop_count, 0);
 122
 123         /*
 124          * Wait for the target to arrive:
 125          */
 126         while (atomic_read(&start_count) != cpus-1)
 127                 cpu_relax();
 128         /*
 129          * Trigger the target to continue into the measurement too:
 130          */
 131         atomic_inc(&start_count);
 132
 133         check_tsc_warp();
 134
 135         while (atomic_read(&stop_count) != cpus-1)
 136                 cpu_relax();
 137
 138         if (nr_warps) {
 139                 printk("\n");
 140                 printk(KERN_WARNING "Measured %Ld cycles TSC warp between CPUs,"
 141                                     " turning off TSC clock.\n", max_warp);
 142                 mark_tsc_unstable("check_tsc_sync_source failed");
 143         } else {
 144                 printk(" passed.\n");
 145         }
 146
 147         /*
 148          * Reset it - just in case we boot another CPU later:
 149          */
 150         atomic_set(&start_count, 0);
 151         nr_warps = 0;
 152         max_warp = 0;
 153         last_tsc = 0;
 154
 155         /*
 156          * Let the target continue with the bootup:
 157          */
 158         atomic_inc(&stop_count);
 159 }
 160
 161 /*
 162  * Freshly booted CPUs call into this:
 163  */
 164 void __cpuinit check_tsc_sync_target(void)
 165 {
 166         int cpus = 2;
 167
 168         if (unsynchronized_tsc())
 169                 return;
 170
 171         /*
 172          * Register this CPU's participation and wait for the
 173          * source CPU to start the measurement:
 174          */
 175         atomic_inc(&start_count);
 176         while (atomic_read(&start_count) != cpus)
 177                 cpu_relax();
 178
 179         check_tsc_warp();
 180
 181         /*
 182          * Ok, we are done:
 183          */
 184         atomic_inc(&stop_count);
 185
 186         /*
 187          * Wait for the source CPU to print stuff:
 188          */
 189         while (atomic_read(&stop_count) != cpus)
 190                 cpu_relax();
 191 }
 192 #undef NR_LOOPS
 193