drm/rcar-du: Configure RGB output routing to DPAD0
[deliverable/linux.git] / drivers / memory / Kconfig
1 #
2 # Memory devices
3 #
4
5 menuconfig MEMORY
6 bool "Memory Controller drivers"
7
8 if MEMORY
9
10 config TI_EMIF
11 tristate "Texas Instruments EMIF driver"
12 depends on ARCH_OMAP2PLUS
13 select DDR
14 help
15 This driver is for the EMIF module available in Texas Instruments
16 SoCs. EMIF is an SDRAM controller that, based on its revision,
17 supports one or more of DDR2, DDR3, and LPDDR2 SDRAM protocols.
18 This driver takes care of only LPDDR2 memories presently. The
19 functions of the driver includes re-configuring AC timing
20 parameters and other settings during frequency, voltage and
21 temperature changes
22
23 config MVEBU_DEVBUS
24 bool "Marvell EBU Device Bus Controller"
25 default y
26 depends on PLAT_ORION && OF
27 help
28 This driver is for the Device Bus controller available in some
29 Marvell EBU SoCs such as Discovery (mv78xx0), Orion (88f5xxx) and
30 Armada 370 and Armada XP. This controller allows to handle flash
31 devices such as NOR, NAND, SRAM, and FPGA.
32
33 config TEGRA20_MC
34 bool "Tegra20 Memory Controller(MC) driver"
35 default y
36 depends on ARCH_TEGRA_2x_SOC
37 help
38 This driver is for the Memory Controller(MC) module available
39 in Tegra20 SoCs, mainly for a address translation fault
40 analysis, especially for IOMMU/GART(Graphics Address
41 Relocation Table) module.
42
43 config TEGRA30_MC
44 bool "Tegra30 Memory Controller(MC) driver"
45 default y
46 depends on ARCH_TEGRA_3x_SOC
47 help
48 This driver is for the Memory Controller(MC) module available
49 in Tegra30 SoCs, mainly for a address translation fault
50 analysis, especially for IOMMU/SMMU(System Memory Management
51 Unit) module.
52
53 endif
This page took 0.032855 seconds and 5 git commands to generate.