drivers/net/ethernet/arc/Kconfig

   1 #
   2 # ARC EMAC network device configuration
   3 #
   4
   5 config NET_VENDOR_ARC
   6         bool "ARC devices"
   7         default y
   8         ---help---
   9           If you have a network (Ethernet) card belonging to this class, say Y.
  10
  11           Note that the answer to this question doesn't directly affect the
  12           kernel: saying N will just cause the configurator to skip all
  13           the questions about ARC cards. If you say Y, you will be asked for
  14           your specific card in the following questions.
  15
  16 if NET_VENDOR_ARC
  17
  18 config ARC_EMAC_CORE
  19         tristate
  20         select MII
  21         select PHYLIB
  22
  23 config ARC_EMAC
  24         tristate "ARC EMAC support"
  25         select ARC_EMAC_CORE
  26         depends on OF_IRQ && OF_NET && HAS_DMA
  27         ---help---
  28           On some legacy ARC (Synopsys) FPGA boards such as ARCAngel4/ML50x
  29           non-standard on-chip ethernet device ARC EMAC 10/100 is used.
  30           Say Y here if you have such a board.  If unsure, say N.
  31
  32 config EMAC_ROCKCHIP
  33         tristate "Rockchip EMAC support"
  34         select ARC_EMAC_CORE
  35         depends on OF_IRQ && OF_NET && REGULATOR && HAS_DMA
  36         ---help---
  37           Support for Rockchip RK3036/RK3066/RK3188 EMAC ethernet controllers.
  38           This selects Rockchip SoC glue layer support for the
  39           emac device driver. This driver is used for RK3036/RK3066/RK3188
  40           EMAC ethernet controller.
  41
  42 endif # NET_VENDOR_ARC