drivers/net/ethernet/mellanox/mlx4/Kconfig

   1 #
   2 # Mellanox driver configuration
   3 #
   4
   5 config MLX4_EN
   6         tristate "Mellanox Technologies 10Gbit Ethernet support"
   7         depends on PCI && INET
   8         select MLX4_CORE
   9         select INET_LRO
  10         ---help---
  11           This driver supports Mellanox Technologies ConnectX Ethernet
  12           devices.
  13
  14 config MLX4_EN_DCB
  15         bool "Data Center Bridging (DCB) Support"
  16         default y
  17         depends on MLX4_EN && DCB
  18         ---help---
  19           Say Y here if you want to use Data Center Bridging (DCB) in the
  20           driver.
  21           If set to N, will not be able to configure QoS and ratelimit attributes.
  22           This flag is depended on the kernel's DCB support.
  23
  24           If unsure, set to Y
  25
  26 config MLX4_CORE
  27         tristate
  28         depends on PCI
  29         default n
  30
  31 config MLX4_DEBUG
  32         bool "Verbose debugging output" if (MLX4_CORE && EXPERT)
  33         depends on MLX4_CORE
  34         default y
  35         ---help---
  36           This option causes debugging code to be compiled into the
  37           mlx4_core driver.  The output can be turned on via the
  38           debug_level module parameter (which can also be set after
  39           the driver is loaded through sysfs).