drivers/net/ethernet/myricom/Kconfig

   1 #
   2 # Myricom device configuration
   3 #
   4
   5 config NET_VENDOR_MYRI
   6         bool "Myricom devices"
   7         default y
   8         depends on PCI && INET
   9         ---help---
  10           If you have a network (Ethernet) card belonging to this class, say
  11           Y and read the Ethernet-HOWTO, available from
  12           <http://www.tldp.org/docs.html#howto>.
  13
  14           Note that the answer to this question doesn't directly affect the
  15           kernel: saying N will just cause the configurator to skip all
  16           the questions about Myricom cards. If you say Y, you will be asked for
  17           your specific card in the following questions.
  18
  19 if NET_VENDOR_MYRI
  20
  21 config MYRI10GE
  22         tristate "Myricom Myri-10G Ethernet support"
  23         depends on PCI && INET
  24         select FW_LOADER
  25         select CRC32
  26         ---help---
  27           This driver supports Myricom Myri-10G Dual Protocol interface in
  28           Ethernet mode. If the eeprom on your board is not recent enough,
  29           you will need a newer firmware image.
  30           You may get this image or more information, at:
  31
  32           <http://www.myri.com/scs/download-Myri10GE.html>
  33
  34           To compile this driver as a module, choose M here. The module
  35           will be called myri10ge.
  36
  37 config MYRI10GE_DCA
  38         bool "Direct Cache Access (DCA) Support"
  39         default y
  40         depends on MYRI10GE && DCA && !(MYRI10GE=y && DCA=m)
  41         ---help---
  42           Say Y here if you want to use Direct Cache Access (DCA) in the
  43           driver.  DCA is a method for warming the CPU cache before data
  44           is used, with the intent of lessening the impact of cache misses.
  45
  46 endif # NET_VENDOR_MYRI