drivers/net/ethernet/myricom/Kconfig

   1 #
   2 # Myricom device configuration
   3 #
   4
   5 config NET_VENDOR_MYRI
   6         bool "Myricom devices"
   7         default y
   8         depends on PCI && INET
   9         ---help---
  10           If you have a network (Ethernet) card belonging to this class, say Y.
  11
  12           Note that the answer to this question doesn't directly affect the
  13           kernel: saying N will just cause the configurator to skip all
  14           the questions about Myricom cards. If you say Y, you will be asked for
  15           your specific card in the following questions.
  16
  17 if NET_VENDOR_MYRI
  18
  19 config MYRI10GE
  20         tristate "Myricom Myri-10G Ethernet support"
  21         depends on PCI && INET
  22         select FW_LOADER
  23         select CRC32
  24         ---help---
  25           This driver supports Myricom Myri-10G Dual Protocol interface in
  26           Ethernet mode. If the eeprom on your board is not recent enough,
  27           you will need a newer firmware image.
  28           You may get this image or more information, at:
  29
  30           <http://www.myri.com/scs/download-Myri10GE.html>
  31
  32           To compile this driver as a module, choose M here. The module
  33           will be called myri10ge.
  34
  35 config MYRI10GE_DCA
  36         bool "Direct Cache Access (DCA) Support"
  37         default y
  38         depends on MYRI10GE && DCA && !(MYRI10GE=y && DCA=m)
  39         ---help---
  40           Say Y here if you want to use Direct Cache Access (DCA) in the
  41           driver.  DCA is a method for warming the CPU cache before data
  42           is used, with the intent of lessening the impact of cache misses.
  43
  44 endif # NET_VENDOR_MYRI