drivers/net/team/Kconfig

   1 menuconfig NET_TEAM
   2         tristate "Ethernet team driver support (EXPERIMENTAL)"
   3         depends on EXPERIMENTAL
   4         ---help---
   5           This allows one to create virtual interfaces that teams together
   6           multiple ethernet devices.
   7
   8           Team devices can be added using the "ip" command from the
   9           iproute2 package:
  10
  11           "ip link add link [ address MAC ] [ NAME ] type team"
  12
  13           To compile this driver as a module, choose M here: the module
  14           will be called team.
  15
  16 if NET_TEAM
  17
  18 config NET_TEAM_MODE_BROADCAST
  19         tristate "Broadcast mode support"
  20         depends on NET_TEAM
  21         ---help---
  22           Basic mode where packets are transmitted always by all suitable ports.
  23
  24           All added ports are setup to have team's mac address.
  25
  26           To compile this team mode as a module, choose M here: the module
  27           will be called team_mode_broadcast.
  28
  29 config NET_TEAM_MODE_ROUNDROBIN
  30         tristate "Round-robin mode support"
  31         depends on NET_TEAM
  32         ---help---
  33           Basic mode where port used for transmitting packets is selected in
  34           round-robin fashion using packet counter.
  35
  36           All added ports are setup to have team's mac address.
  37
  38           To compile this team mode as a module, choose M here: the module
  39           will be called team_mode_roundrobin.
  40
  41 config NET_TEAM_MODE_ACTIVEBACKUP
  42         tristate "Active-backup mode support"
  43         depends on NET_TEAM
  44         ---help---
  45           Only one port is active at a time and the rest of ports are used
  46           for backup.
  47
  48           Mac addresses of ports are not modified. Userspace is responsible
  49           to do so.
  50
  51           To compile this team mode as a module, choose M here: the module
  52           will be called team_mode_activebackup.
  53
  54 config NET_TEAM_MODE_LOADBALANCE
  55         tristate "Load-balance mode support"
  56         depends on NET_TEAM
  57         ---help---
  58           This mode provides load balancing functionality. Tx port selection
  59           is done using BPF function set up from userspace (bpf_hash_func
  60           option)
  61
  62           To compile this team mode as a module, choose M here: the module
  63           will be called team_mode_loadbalance.
  64
  65 endif # NET_TEAM