drivers/net/team/Kconfig

   1 menuconfig NET_TEAM
   2         tristate "Ethernet team driver support"
   3         ---help---
   4           This allows one to create virtual interfaces that teams together
   5           multiple ethernet devices.
   6
   7           Team devices can be added using the "ip" command from the
   8           iproute2 package:
   9
  10           "ip link add link [ address MAC ] [ NAME ] type team"
  11
  12           To compile this driver as a module, choose M here: the module
  13           will be called team.
  14
  15 if NET_TEAM
  16
  17 config NET_TEAM_MODE_BROADCAST
  18         tristate "Broadcast mode support"
  19         depends on NET_TEAM
  20         ---help---
  21           Basic mode where packets are transmitted always by all suitable ports.
  22
  23           All added ports are setup to have team's device address.
  24
  25           To compile this team mode as a module, choose M here: the module
  26           will be called team_mode_broadcast.
  27
  28 config NET_TEAM_MODE_ROUNDROBIN
  29         tristate "Round-robin mode support"
  30         depends on NET_TEAM
  31         ---help---
  32           Basic mode where port used for transmitting packets is selected in
  33           round-robin fashion using packet counter.
  34
  35           All added ports are setup to have team's device address.
  36
  37           To compile this team mode as a module, choose M here: the module
  38           will be called team_mode_roundrobin.
  39
  40 config NET_TEAM_MODE_ACTIVEBACKUP
  41         tristate "Active-backup mode support"
  42         depends on NET_TEAM
  43         ---help---
  44           Only one port is active at a time and the rest of ports are used
  45           for backup.
  46
  47           Mac addresses of ports are not modified. Userspace is responsible
  48           to do so.
  49
  50           To compile this team mode as a module, choose M here: the module
  51           will be called team_mode_activebackup.
  52
  53 config NET_TEAM_MODE_LOADBALANCE
  54         tristate "Load-balance mode support"
  55         depends on NET_TEAM
  56         ---help---
  57           This mode provides load balancing functionality. Tx port selection
  58           is done using BPF function set up from userspace (bpf_hash_func
  59           option)
  60
  61           To compile this team mode as a module, choose M here: the module
  62           will be called team_mode_loadbalance.
  63
  64 endif # NET_TEAM