drivers/usb/atm/Kconfig

   1 #
   2 # USB/ATM DSL configuration
   3 #
   4
   5 menu "USB DSL modem support"
   6         depends on USB
   7
   8 config USB_ATM
   9         tristate "USB DSL modem support"
  10         depends on USB && ATM
  11         select CRC32
  12         default n
  13         help
  14           Say Y here if you want to connect a USB Digital Subscriber Line (DSL)
  15           modem to your computer's USB port.  You will then need to choose your
  16           modem from the list below.
  17
  18           To compile this driver as a module, choose M here: the
  19           module will be called usbatm.
  20
  21 config USB_SPEEDTOUCH
  22         tristate "Speedtouch USB support"
  23         depends on USB_ATM
  24         select FW_LOADER
  25         help
  26           Say Y here if you have an SpeedTouch USB or SpeedTouch 330
  27           modem.  In order to use your modem you will need to install the
  28           two parts of the firmware, extracted by the user space tools; see
  29           <http://www.linux-usb.org/SpeedTouch/> for details.
  30
  31           To compile this driver as a module, choose M here: the
  32           module will be called speedtch.
  33
  34 config USB_CXACRU
  35         tristate "Conexant AccessRunner USB support"
  36         depends on USB_ATM
  37         select FW_LOADER
  38         help
  39           Say Y here if you have an ADSL USB modem based on the Conexant
  40           AccessRunner chipset.  In order to use your modem you will need to
  41           install the firmware, extracted by the user space tools; see
  42           <http://accessrunner.sourceforge.net/> for details.
  43
  44           To compile this driver as a module, choose M here: the
  45           module will be called cxacru.
  46
  47 config USB_XUSBATM
  48         tristate "Other USB DSL modem support"
  49         depends on USB_ATM
  50         help
  51           Say Y here if you have a DSL USB modem not explicitly supported by
  52           another USB DSL drivers.  In order to use your modem you will need to
  53           pass the vendor ID, product ID, and endpoint numbers for transmission
  54           and reception as module parameters.  You may need to initialize the
  55           the modem using a user space utility (a firmware loader for example).
  56
  57           To compile this driver as a module, choose M here: the
  58           module will be called xusbatm.
  59
  60 endmenu