drivers/w1/masters/Kconfig

   1 #
   2 # 1-wire bus master configuration
   3 #
   4
   5 menu "1-wire Bus Masters"
   6
   7 config W1_MASTER_MATROX
   8         tristate "Matrox G400 transport layer for 1-wire"
   9         depends on PCI
  10         help
  11           Say Y here if you want to communicate with your 1-wire devices
  12           using Matrox's G400 GPIO pins.
  13
  14           This support is also available as a module.  If so, the module
  15           will be called matrox_w1.ko.
  16
  17 config W1_MASTER_DS2490
  18         tristate "DS2490 USB <-> W1 transport layer for 1-wire"
  19         depends on USB
  20         help
  21           Say Y here if you want to have a driver for DS2490 based USB <-> W1 bridges,
  22           for example DS9490*.
  23
  24           This support is also available as a module.  If so, the module
  25           will be called ds2490.ko.
  26
  27 config W1_MASTER_DS2482
  28         tristate "Maxim DS2482 I2C to 1-Wire bridge"
  29         depends on I2C && EXPERIMENTAL
  30         help
  31           If you say yes here you get support for the Maxim DS2482
  32           I2C to 1-Wire bridge.
  33
  34           This driver can also be built as a module.  If so, the module
  35           will be called ds2482.
  36
  37 config W1_MASTER_MXC
  38         tristate "Freescale MXC 1-wire busmaster"
  39         depends on W1 && ARCH_MXC
  40         help
  41           Say Y here to enable MXC 1-wire host
  42
  43 config W1_MASTER_DS1WM
  44         tristate "Maxim DS1WM 1-wire busmaster"
  45         depends on W1 && ARM && HAVE_CLK
  46         help
  47           Say Y here to enable the DS1WM 1-wire driver, such as that
  48           in HP iPAQ devices like h5xxx, h2200, and ASIC3-based like
  49           hx4700.
  50
  51 config W1_MASTER_GPIO
  52         tristate "GPIO 1-wire busmaster"
  53         depends on GENERIC_GPIO
  54         help
  55           Say Y here if you want to communicate with your 1-wire devices using
  56           GPIO pins. This driver uses the GPIO API to control the wire.
  57
  58           This support is also available as a module.  If so, the module
  59           will be called w1-gpio.ko.
  60
  61 config HDQ_MASTER_OMAP
  62         tristate "OMAP HDQ driver"
  63         depends on ARCH_OMAP2430 || ARCH_OMAP34XX
  64         help
  65           Say Y here if you want support for the 1-wire or HDQ Interface
  66           on an OMAP processor.
  67
  68 endmenu
  69