can: mcp251x: Allow pass IRQ flags through platform data.
[deliverable/linux.git] / include / linux / can / platform / mcp251x.h
1 #ifndef __CAN_PLATFORM_MCP251X_H__
2 #define __CAN_PLATFORM_MCP251X_H__
3
4 /*
5 *
6 * CAN bus driver for Microchip 251x CAN Controller with SPI Interface
7 *
8 */
9
10 #include <linux/spi/spi.h>
11
12 /**
13 * struct mcp251x_platform_data - MCP251X SPI CAN controller platform data
14 * @oscillator_frequency: - oscillator frequency in Hz
15 * @irq_flags: - IRQF configuration flags
16 * @board_specific_setup: - called before probing the chip (power,reset)
17 * @transceiver_enable: - called to power on/off the transceiver
18 * @power_enable: - called to power on/off the mcp *and* the
19 * transceiver
20 *
21 * Please note that you should define power_enable or transceiver_enable or
22 * none of them. Defining both of them is no use.
23 *
24 */
25
26 struct mcp251x_platform_data {
27 unsigned long oscillator_frequency;
28 unsigned long irq_flags;
29 int (*board_specific_setup)(struct spi_device *spi);
30 int (*transceiver_enable)(int enable);
31 int (*power_enable) (int enable);
32 };
33
34 #endif /* __CAN_PLATFORM_MCP251X_H__ */
This page took 0.033439 seconds and 5 git commands to generate.