-arc-*-*)
- multidirs="be"
- ;;
-# end-sanitize-arc
-hppa*-*-*)
- multidirs="soft-float"
- ;;
-#m68*-*-aout* | m68*-*-coff* | m68*-*-elf* | m68*-*-vxworks*)
-# multidirs="m68000 m68020 m68881 msoft-float m68000/m68881 m68000/msoft-float m68020/m68881 m68020/msoft-float"
-# ;;
-m68*-*-aout* | m68*-*-coff* | m68*-*-elf* | m68*-*-vxworks*)
- multidirs="m68000 m68000/m68881"
- ;;
-i960-*-*)
- multidirs=float
- ;;
-sparclite-*-* | sparclitefrw*-*-*)
- multidirs="mfpu msoft-float mflat mno-flat mfpu/mflat mfpu/mno-flat msoft-float/mflat msoft-float/mno-flat"
- ;;
-sparc-*-* | sparcfrw*-*-*)
- multidirs="soft v8 soft/v8"
- ;;
-z8k-*-coff)
- multidirs="z8001 std z8001/std"
- ;;
-h8300-*-*)
- multidirs=h8300h
- ;;
-h8500-*-*)
- multidirs="mbig msmall mcompact mmedium"
- ;;
-# start-sanitize-jaguar
-jaguar-*-*)
- multidirs="be"
- ;;
-# end-sanitize-jaguar
-sh-*-*)
- multidirs="ml m2 ml/m2"
-# start-sanitize-sh3e
- multidirs="ml m2 ml/m2 m3e ml/m3e"
-# end-sanitize-sh3e
- ;;
-mips*-*-*)
- # Note that not all of these will be built for a particular
- # target; what is build depends upon the output gcc
- # --print-multi-lib. We configure them all, to make our life
- # simpler here. If somebody cares about configuration
- # efficiency, they will need to switch off on the various
- # targets to configure just the directories needed for that
- # target.
- #
- # In the long run, it would be better to configure based on
- # the output of gcc --print-multi-lib, but, to do that, we
- # would have to build gcc before configuring newlib.
- #
- # Default to including the single-float directories.
- if [ x$enable_single_float = x ]; then
- enable_single_float=yes