- add_com ("while", class_support, while_command, _("\
-Execute nested commands WHILE the conditional expression is non zero.\n\
-The conditional expression must follow the word `while' and must in turn be\n\
-followed by a new line. The nested commands must be entered one per line,\n\
-and should be terminated by the word `end'."));
-
- add_com ("if", class_support, if_command, _("\
-Execute nested commands once IF the conditional expression is non zero.\n\
-The conditional expression must follow the word `if' and must in turn be\n\
-followed by a new line. The nested commands must be entered one per line,\n\
-and should be terminated by the word 'else' or `end'. If an else clause\n\
-is used, the same rules apply to its nested commands as to the first ones."));
-
- /* If target is open when baud changes, it doesn't take effect until
- the next open (I think, not sure). */
- add_setshow_zinteger_cmd ("remotebaud", no_class, &baud_rate, _("\
-Set baud rate for remote serial I/O."), _("\
-Show baud rate for remote serial I/O."), _("\
-This value is used to set the speed of the serial port when debugging\n\
-using remote targets."),
- NULL,
- show_baud_rate,
- &setlist, &showlist);
+ add_cmd ("configuration", no_set_class, show_configuration,
+ _("Show how GDB was configured at build time."), &showlist);