-* FSMC NAND
+ST Microelectronics Flexible Static Memory Controller (FSMC)
+NAND Interface
Required properties:
- compatible : "st,spear600-fsmc-nand", "stericsson,fsmc-nand"
- bank-width : Width (in bytes) of the device. If not present, the width
defaults to 1 byte
- nand-skip-bbtscan: Indicates the the BBT scanning should be skipped
+- timings: array of 6 bytes for NAND timings. The meanings of these bytes
+ are:
+ byte 0 TCLR : CLE to RE delay in number of AHB clock cycles, only 4 bits
+ are valid. Zero means one clockcycle, 15 means 16 clock
+ cycles.
+ byte 1 TAR : ALE to RE delay, 4 bits are valid. Same format as TCLR.
+ byte 2 THIZ : number of HCLK clock cycles during which the data bus is
+ kept in Hi-Z (tristate) after the start of a write access.
+ Only valid for write transactions. Zero means zero cycles,
+ 255 means 255 cycles.
+ byte 3 THOLD : number of HCLK clock cycles to hold the address (and data
+ when writing) after the command deassertation. Zero means
+ one cycle, 255 means 256 cycles.
+ byte 4 TWAIT : number of HCLK clock cycles to assert the command to the
+ NAND flash in response to SMWAITn. Zero means 1 cycle,
+ 255 means 256 cycles.
+ byte 5 TSET : number of HCLK clock cycles to assert the address before the
+ command is asserted. Zero means one cycle, 255 means 256
+ cycles.
+- bank: default NAND bank to use (0-3 are valid, 0 is the default).
Example:
bank-width = <1>;
nand-skip-bbtscan;
+ timings = /bits/ 8 <0 0 0 2 3 0>;
+ bank = <1>;
partition@0 {
...