#include <asm/mach/time.h>
#include <asm/mach/map.h>
-#include <mach/eukrea-baseboards.h>
#include <mach/common.h>
#include <mach/hardware.h>
#include <mach/iomux-mx27.h>
#include <mach/ulpi.h>
#include "devices-imx27.h"
+#include "eukrea-baseboards.h"
static const int eukrea_cpuimx27_pins[] __initconst = {
/* UART1 */
static struct plat_serial8250_port serial_platform_data[] = {
{
.mapbase = (unsigned long)(MX27_CS3_BASE_ADDR + 0x200000),
- .irq = IRQ_GPIOB(23),
+ /* irq number is run-time assigned */
.uartclk = 14745600,
.regshift = 1,
.iotype = UPIO_MEM,
.flags = UPF_BOOT_AUTOCONF | UPF_SKIP_TEST | UPF_IOREMAP,
}, {
.mapbase = (unsigned long)(MX27_CS3_BASE_ADDR + 0x400000),
- .irq = IRQ_GPIOB(22),
+ /* irq number is run-time assigned */
.uartclk = 14745600,
.regshift = 1,
.iotype = UPIO_MEM,
.flags = UPF_BOOT_AUTOCONF | UPF_SKIP_TEST | UPF_IOREMAP,
}, {
.mapbase = (unsigned long)(MX27_CS3_BASE_ADDR + 0x800000),
- .irq = IRQ_GPIOB(27),
+ /* irq number is run-time assigned */
.uartclk = 14745600,
.regshift = 1,
.iotype = UPIO_MEM,
.flags = UPF_BOOT_AUTOCONF | UPF_SKIP_TEST | UPF_IOREMAP,
}, {
.mapbase = (unsigned long)(MX27_CS3_BASE_ADDR + 0x1000000),
- .irq = IRQ_GPIOB(30),
+ /* irq number is run-time assigned */
.uartclk = 14745600,
.regshift = 1,
.iotype = UPIO_MEM,
#endif
#if defined(CONFIG_SERIAL_8250) || defined(CONFIG_SERIAL_8250_MODULE)
+ serial_platform_data[0].irq = IMX_GPIO_NR(2, 23);
+ serial_platform_data[1].irq = IMX_GPIO_NR(2, 22);
+ serial_platform_data[2].irq = IMX_GPIO_NR(2, 27);
+ serial_platform_data[3].irq = IMX_GPIO_NR(2, 30);
platform_device_register(&serial_device);
#endif