#include <linux/errno.h>
#include <linux/delay.h>
#include <linux/device.h>
-#include <linux/jiffies.h>
#include <linux/smp.h>
#include <linux/io.h>
-#include <asm/cacheflush.h>
#include <asm/cputype.h>
-#include <asm/mach-types.h>
#include <asm/smp_plat.h>
#include "scm-boot.h"
#define SCSS_CPU1CORE_RESET 0xD80
#define SCSS_DBG_STATUS_CORE_PWRDUP 0xE64
-extern void msm_secondary_startup(void);
+extern void secondary_startup(void);
static DEFINE_SPINLOCK(boot_lock);
+#ifdef CONFIG_HOTPLUG_CPU
+static void __ref msm_cpu_die(unsigned int cpu)
+{
+ wfi();
+}
+#endif
+
static inline int get_core_count(void)
{
/* 1 + the PART[1:0] field of MIDR */
static void msm_secondary_init(unsigned int cpu)
{
- /*
- * let the primary processor know we're out of the
- * pen, then head off into the C entry point
- */
- pen_release = -1;
- smp_wmb();
-
/*
* Synchronise with the boot thread.
*/
static void prepare_cold_cpu(unsigned int cpu)
{
int ret;
- ret = scm_set_boot_addr(virt_to_phys(msm_secondary_startup),
+ ret = scm_set_boot_addr(virt_to_phys(secondary_startup),
SCM_FLAG_COLDBOOT_CPU1);
if (ret == 0) {
void __iomem *sc1_base_ptr;
static int msm_boot_secondary(unsigned int cpu, struct task_struct *idle)
{
- unsigned long timeout;
static int cold_boot_done;
/* Only need to bring cpu out of reset this way once */
*/
spin_lock(&boot_lock);
- /*
- * The secondary processor is waiting to be released from
- * the holding pen - release it, then wait for it to flag
- * that it has been released by resetting pen_release.
- *
- * Note that "pen_release" is the hardware CPU ID, whereas
- * "cpu" is Linux's internal ID.
- */
- pen_release = cpu_logical_map(cpu);
- sync_cache_w(&pen_release);
-
/*
* Send the secondary CPU a soft interrupt, thereby causing
* the boot monitor to read the system wide flags register,
*/
arch_send_wakeup_ipi_mask(cpumask_of(cpu));
- timeout = jiffies + (1 * HZ);
- while (time_before(jiffies, timeout)) {
- smp_rmb();
- if (pen_release == -1)
- break;
-
- udelay(10);
- }
-
/*
* now the secondary core is starting up let it run its
* calibrations, then wait for it to finish
*/
spin_unlock(&boot_lock);
- return pen_release != -1 ? -ENOSYS : 0;
+ return 0;
}
/*