#include <plat/omap-serial.h>
#include "common.h"
-#include <plat/board.h>
#include <plat/dma.h>
#include <plat/omap_hwmod.h>
#include <plat/omap_device.h>
#include <plat/omap-pm.h>
+#include <plat/serial.h>
#include "prm2xxx_3xxx.h"
#include "pm.h"
};
#ifdef CONFIG_PM
-static void omap_uart_enable_wakeup(struct platform_device *pdev, bool enable)
+static void omap_uart_enable_wakeup(struct device *dev, bool enable)
{
+ struct platform_device *pdev = to_platform_device(dev);
struct omap_device *od = to_omap_device(pdev);
if (!od)
* in Smartidle Mode When Configured for DMA Operations.
* WA: configure uart in force idle mode.
*/
-static void omap_uart_set_noidle(struct platform_device *pdev)
+static void omap_uart_set_noidle(struct device *dev)
{
+ struct platform_device *pdev = to_platform_device(dev);
struct omap_device *od = to_omap_device(pdev);
omap_hwmod_set_slave_idlemode(od->hwmods[0], HWMOD_IDLEMODE_NO);
}
-static void omap_uart_set_smartidle(struct platform_device *pdev)
+static void omap_uart_set_smartidle(struct device *dev)
{
+ struct platform_device *pdev = to_platform_device(dev);
struct omap_device *od = to_omap_device(pdev);
u8 idlemode;
}
#else
-static void omap_uart_enable_wakeup(struct platform_device *pdev, bool enable)
+static void omap_uart_enable_wakeup(struct device *dev, bool enable)
{}
-static void omap_uart_set_noidle(struct platform_device *pdev) {}
-static void omap_uart_set_smartidle(struct platform_device *pdev) {}
+static void omap_uart_set_noidle(struct device *dev) {}
+static void omap_uart_set_smartidle(struct device *dev) {}
#endif /* CONFIG_PM */
#ifdef CONFIG_OMAP_MUX
omap_up.dma_rx_timeout = info->dma_rx_timeout;
omap_up.dma_rx_poll_rate = info->dma_rx_poll_rate;
omap_up.autosuspend_timeout = info->autosuspend_timeout;
+ omap_up.DTR_gpio = info->DTR_gpio;
+ omap_up.DTR_inverted = info->DTR_inverted;
+ omap_up.DTR_present = info->DTR_present;
pdata = &omap_up;
pdata_size = sizeof(struct omap_uart_port_info);