* Preserves: tbl, flags
* Corrupts: phys, start, end, pstate
*/
- .macro create_block_map, tbl, flags, phys, start, end, idmap=0
+ .macro create_block_map, tbl, flags, phys, start, end
lsr \phys, \phys, #BLOCK_SHIFT
- .if \idmap
- and \start, \phys, #PTRS_PER_PTE - 1 // table index
- .else
lsr \start, \start, #BLOCK_SHIFT
and \start, \start, #PTRS_PER_PTE - 1 // table index
- .endif
orr \phys, \flags, \phys, lsl #BLOCK_SHIFT // table entry
- .ifnc \start,\end
lsr \end, \end, #BLOCK_SHIFT
and \end, \end, #PTRS_PER_PTE - 1 // table end index
- .endif
9999: str \phys, [\tbl, \start, lsl #3] // store the entry
- .ifnc \start,\end
add \start, \start, #1 // next entry
add \phys, \phys, #BLOCK_SIZE // next block
cmp \start, \end
b.ls 9999b
- .endif
.endm
/*
* - identity mapping to enable the MMU (low address, TTBR0)
* - first few MB of the kernel linear mapping to jump to once the MMU has
* been enabled, including the FDT blob (TTBR1)
- * - UART mapping if CONFIG_EARLY_PRINTK is enabled (TTBR1)
+ * - pgd entry for fixed mappings (TTBR1)
*/
__create_page_tables:
pgtbl x25, x26, x24 // idmap_pg_dir and swapper_pg_dir addresses
* Create the identity mapping.
*/
add x0, x25, #PAGE_SIZE // section table address
- adr x3, __turn_mmu_on // virtual/physical address
+ ldr x3, =KERNEL_START
+ add x3, x3, x28 // __pa(KERNEL_START)
create_pgd_entry x25, x0, x3, x5, x6
- create_block_map x0, x7, x3, x5, x5, idmap=1
+ ldr x6, =KERNEL_END
+ mov x5, x3 // __pa(KERNEL_START)
+ add x6, x6, x28 // __pa(KERNEL_END)
+ create_block_map x0, x7, x3, x5, x6
/*
* Map the kernel image (starting with PHYS_OFFSET).
add x0, x26, #PAGE_SIZE // section table address
mov x5, #PAGE_OFFSET
create_pgd_entry x26, x0, x5, x3, x6
- ldr x6, =KERNEL_END - 1
+ ldr x6, =KERNEL_END
mov x3, x24 // phys offset
create_block_map x0, x7, x3, x5, x6
sub x6, x6, #1 // inclusive range
create_block_map x0, x7, x3, x5, x6
1:
-#ifdef CONFIG_EARLY_PRINTK
/*
- * Create the pgd entry for the UART mapping. The full mapping is done
- * later based earlyprintk kernel parameter.
+ * Create the pgd entry for the fixed mappings.
*/
- ldr x5, =EARLYCON_IOBASE // UART virtual address
+ ldr x5, =FIXADDR_TOP // Fixed mapping virtual address
add x0, x26, #2 * PAGE_SIZE // section table address
create_pgd_entry x26, x0, x5, x6, x7
-#endif
ret
ENDPROC(__create_page_tables)
.ltorg