#include <linux/ata.h>
#define DRV_NAME "pata_jmicron"
-#define DRV_VERSION "0.1.4"
+#define DRV_VERSION "0.1.5"
typedef enum {
PORT_PATA0 = 0,
/**
* jmicron_pre_reset - check for 40/80 pin
* @ap: Port
+ * @deadline: deadline jiffies for the operation
*
* Perform the PATA port setup we need.
-
+ *
* On the Jmicron 361/363 there is a single PATA port that can be mapped
* either as primary or secondary (or neither). We don't do any policy
* and setup here. We assume that has been done by init_one and the
* BIOS.
*/
-static int jmicron_pre_reset(struct ata_port *ap)
+static int jmicron_pre_reset(struct ata_port *ap, unsigned long deadline)
{
struct pci_dev *pdev = to_pci_dev(ap->host->dev);
u32 control;
ap->cbl = ATA_CBL_SATA;
break;
}
- return ata_std_prereset(ap);
+ return ata_std_prereset(ap, deadline);
}
/**
static int jmicron_init_one (struct pci_dev *pdev, const struct pci_device_id *id)
{
- static struct ata_port_info info = {
+ static const struct ata_port_info info = {
.sht = &jmicron_sht,
.flags = ATA_FLAG_SLAVE_POSS | ATA_FLAG_SRST,
.port_ops = &jmicron_ops,
};
- struct ata_port_info *port_info[2] = { &info, &info };
+ const struct ata_port_info *ppi[] = { &info, NULL };
- return ata_pci_init_one(pdev, port_info, 2);
+ return ata_pci_init_one(pdev, ppi);
}
static const struct pci_device_id jmicron_pci_tbl[] = {
.id_table = jmicron_pci_tbl,
.probe = jmicron_init_one,
.remove = ata_pci_remove_one,
+#ifdef CONFIG_PM
.suspend = ata_pci_device_suspend,
.resume = ata_pci_device_resume,
+#endif
};
static int __init jmicron_init(void)