struct usbhid_device *usbhid = hid->driver_data;
spin_lock_irqsave(&usbhid->lock, flags);
- if (hid->open > 0 &&
+ if ((hid->open > 0 || hid->quirks & HID_QUIRK_ALWAYS_POLL) &&
!test_bit(HID_DISCONNECTED, &usbhid->iofl) &&
!test_bit(HID_SUSPENDED, &usbhid->iofl) &&
!test_and_set_bit(HID_IN_RUNNING, &usbhid->iofl)) {
struct usbhid_device *usbhid =
container_of(work, struct usbhid_device, reset_work);
struct hid_device *hid = usbhid->hid;
- int rc = 0;
+ int rc;
if (test_bit(HID_CLEAR_HALT, &usbhid->iofl)) {
dev_dbg(&usbhid->intf->dev, "clear halt\n");
rc = usb_clear_halt(hid_to_usb_dev(hid), usbhid->urbin->pipe);
clear_bit(HID_CLEAR_HALT, &usbhid->iofl);
- hid_start_in(hid);
- }
-
- else if (test_bit(HID_RESET_PENDING, &usbhid->iofl)) {
- dev_dbg(&usbhid->intf->dev, "resetting device\n");
- rc = usb_lock_device_for_reset(hid_to_usb_dev(hid), usbhid->intf);
if (rc == 0) {
- rc = usb_reset_device(hid_to_usb_dev(hid));
- usb_unlock_device(hid_to_usb_dev(hid));
+ hid_start_in(hid);
+ } else {
+ dev_dbg(&usbhid->intf->dev,
+ "clear-halt failed: %d\n", rc);
+ set_bit(HID_RESET_PENDING, &usbhid->iofl);
}
- clear_bit(HID_RESET_PENDING, &usbhid->iofl);
}
- switch (rc) {
- case 0:
- if (!test_bit(HID_IN_RUNNING, &usbhid->iofl))
- hid_io_error(hid);
- break;
- default:
- hid_err(hid, "can't reset device, %s-%s/input%d, status %d\n",
- hid_to_usb_dev(hid)->bus->bus_name,
- hid_to_usb_dev(hid)->devpath,
- usbhid->ifnum, rc);
- /* FALLTHROUGH */
- case -EHOSTUNREACH:
- case -ENODEV:
- case -EINTR:
- break;
+ if (test_bit(HID_RESET_PENDING, &usbhid->iofl)) {
+ dev_dbg(&usbhid->intf->dev, "resetting device\n");
+ usb_queue_reset_device(usbhid->intf);
}
}
case 0: /* success */
usbhid_mark_busy(usbhid);
usbhid->retry_delay = 0;
- hid_input_report(urb->context, HID_INPUT_REPORT,
- urb->transfer_buffer,
- urb->actual_length, 1);
- /*
- * autosuspend refused while keys are pressed
- * because most keyboards don't wake up when
- * a key is released
- */
- if (hid_check_keys_pressed(hid))
- set_bit(HID_KEYS_PRESSED, &usbhid->iofl);
- else
- clear_bit(HID_KEYS_PRESSED, &usbhid->iofl);
+ if ((hid->quirks & HID_QUIRK_ALWAYS_POLL) && !hid->open)
+ break;
+ if (!test_bit(HID_RESUME_RUNNING, &usbhid->iofl)) {
+ hid_input_report(urb->context, HID_INPUT_REPORT,
+ urb->transfer_buffer,
+ urb->actual_length, 1);
+ /*
+ * autosuspend refused while keys are pressed
+ * because most keyboards don't wake up when
+ * a key is released
+ */
+ if (hid_check_keys_pressed(hid))
+ set_bit(HID_KEYS_PRESSED, &usbhid->iofl);
+ else
+ clear_bit(HID_KEYS_PRESSED, &usbhid->iofl);
+ }
break;
case -EPIPE: /* stall */
usbhid_mark_busy(usbhid);
goto done;
}
usbhid->intf->needs_remote_wakeup = 1;
+ set_bit(HID_RESUME_RUNNING, &usbhid->iofl);
res = hid_start_in(hid);
if (res) {
if (res != -ENOSPC) {
}
}
usb_autopm_put_interface(usbhid->intf);
+
+ /*
+ * In case events are generated while nobody was listening,
+ * some are released when the device is re-opened.
+ * Wait 50 msec for the queue to empty before allowing events
+ * to go through hid.
+ */
+ msleep(50);
+ clear_bit(HID_RESUME_RUNNING, &usbhid->iofl);
}
done:
mutex_unlock(&hid_open_mut);
if (!--hid->open) {
spin_unlock_irq(&usbhid->lock);
hid_cancel_delayed_stuff(usbhid);
- usb_kill_urb(usbhid->urbin);
- usbhid->intf->needs_remote_wakeup = 0;
+ if (!(hid->quirks & HID_QUIRK_ALWAYS_POLL)) {
+ usb_kill_urb(usbhid->urbin);
+ usbhid->intf->needs_remote_wakeup = 0;
+ }
} else {
spin_unlock_irq(&usbhid->lock);
}
set_bit(HID_STARTED, &usbhid->iofl);
+ if (hid->quirks & HID_QUIRK_ALWAYS_POLL) {
+ ret = usb_autopm_get_interface(usbhid->intf);
+ if (ret)
+ goto fail;
+ usbhid->intf->needs_remote_wakeup = 1;
+ ret = hid_start_in(hid);
+ if (ret) {
+ dev_err(&hid->dev,
+ "failed to start in urb: %d\n", ret);
+ }
+ usb_autopm_put_interface(usbhid->intf);
+ }
+
/* Some keyboards don't work until their LEDs have been set.
* Since BIOSes do set the LEDs, it must be safe for any device
* that supports the keyboard boot protocol.
if (WARN_ON(!usbhid))
return;
+ if (hid->quirks & HID_QUIRK_ALWAYS_POLL)
+ usbhid->intf->needs_remote_wakeup = 0;
+
clear_bit(HID_STARTED, &usbhid->iofl);
spin_lock_irq(&usbhid->lock); /* Sync with error and led handlers */
set_bit(HID_DISCONNECTED, &usbhid->iofl);