MPT_ADAPTER *ioc = pci_get_drvdata(pdev);
u32 device_state = pdev->current_state;
int recovery_state;
+ int err;
printk(MYIOC_s_INFO_FMT
"pci-resume: pdev=0x%p, slot=%s, Previous operating state [D%d]\n",
pci_set_power_state(pdev, 0);
pci_restore_state(pdev);
- pci_enable_device(pdev);
+ err = pci_enable_device(pdev);
+ if (err)
+ return err;
/* enable interrupts */
CHIPREG_WRITE32(&ioc->chip->IntMask, MPI_HIM_DIM);
* index = chain_idx
*
* Calculate the number of chain buffers needed(plus 1) per I/O
- * then multiply the the maximum number of simultaneous cmds
+ * then multiply the maximum number of simultaneous cmds
*
* num_sge = num sge in request frame + last chain buffer
* scale = num sge per chain buffer if no chain element
}
/**
- * mpt_inactive_raid_list_free
- *
- * This clears this link list.
- *
- * @ioc - pointer to per adapter structure
- *
+ * mpt_inactive_raid_list_free - This clears this link list.
+ * @ioc : pointer to per adapter structure
**/
static void
mpt_inactive_raid_list_free(MPT_ADAPTER *ioc)
}
/**
- * mpt_inactive_raid_volumes
- *
- * This sets up link list of phy_disk_nums for devices belonging in an inactive volume
- *
- * @ioc - pointer to per adapter structure
- * @channel - volume channel
- * @id - volume target id
- *
+ * mpt_inactive_raid_volumes - sets up link list of phy_disk_nums for devices belonging in an inactive volume
*
+ * @ioc : pointer to per adapter structure
+ * @channel : volume channel
+ * @id : volume target id
**/
static void
mpt_inactive_raid_volumes(MPT_ADAPTER *ioc, u8 channel, u8 id)
/**
* mpt_iocstatus_info_config - IOCSTATUS information for config pages
* @ioc: Pointer to MPT_ADAPTER structure
- * ioc_status: U32 IOCStatus word from IOC
+ * @ioc_status: U32 IOCStatus word from IOC
* @mf: Pointer to MPT request frame
*
* Refer to lsi/mpi.h.