#include <asm/sizes.h>
#include "mmci.h"
+#include "mmci_qcom_dml.h"
#define DRIVER_NAME "mmci-pl18x"
* @blksz_datactrl16: true if Block size is at b16..b30 position in datactrl register
* @blksz_datactrl4: true if Block size is at b4..b16 position in datactrl
* register
+ * @datactrl_mask_sdio: SDIO enable mask in datactrl register
* @pwrreg_powerup: power up value for MMCIPOWER register
* @f_max: maximum clk frequency supported by the controller.
* @signal_direction: input/out direction of bus signals can be indicated
* @pwrreg_nopower: bits in MMCIPOWER don't controls ext. power supply
* @explicit_mclk_control: enable explicit mclk control in driver.
* @qcom_fifo: enables qcom specific fifo pio read logic.
+ * @qcom_dml: enables qcom specific dma glue for dma transfers.
* @reversed_irq_handling: handle data irq before cmd irq.
*/
struct variant_data {
unsigned int fifohalfsize;
unsigned int data_cmd_enable;
unsigned int datactrl_mask_ddrmode;
+ unsigned int datactrl_mask_sdio;
bool sdio;
bool st_clkdiv;
bool blksz_datactrl16;
bool pwrreg_nopower;
bool explicit_mclk_control;
bool qcom_fifo;
+ bool qcom_dml;
bool reversed_irq_handling;
};
.clkreg_enable = MCI_ST_U300_HWFCEN,
.clkreg_8bit_bus_enable = MCI_ST_8BIT_BUS,
.datalength_bits = 16,
+ .datactrl_mask_sdio = MCI_ST_DPSM_SDIOEN,
.sdio = true,
.pwrreg_powerup = MCI_PWR_ON,
.f_max = 100000000,
.fifohalfsize = 8 * 4,
.clkreg = MCI_CLK_ENABLE,
.datalength_bits = 24,
+ .datactrl_mask_sdio = MCI_ST_DPSM_SDIOEN,
.sdio = true,
.st_clkdiv = true,
.pwrreg_powerup = MCI_PWR_ON,
.clkreg_8bit_bus_enable = MCI_ST_8BIT_BUS,
.clkreg_neg_edge_enable = MCI_ST_UX500_NEG_EDGE,
.datalength_bits = 24,
+ .datactrl_mask_sdio = MCI_ST_DPSM_SDIOEN,
.sdio = true,
.st_clkdiv = true,
.pwrreg_powerup = MCI_PWR_ON,
.clkreg_neg_edge_enable = MCI_ST_UX500_NEG_EDGE,
.datactrl_mask_ddrmode = MCI_ST_DPSM_DDRMODE,
.datalength_bits = 24,
+ .datactrl_mask_sdio = MCI_ST_DPSM_SDIOEN,
.sdio = true,
.st_clkdiv = true,
.blksz_datactrl16 = true,
.f_max = 208000000,
.explicit_mclk_control = true,
.qcom_fifo = true,
+ .qcom_dml = true,
};
static int mmci_card_busy(struct mmc_host *mmc)
{
const char *rxname, *txname;
dma_cap_mask_t mask;
+ struct variant_data *variant = host->variant;
host->dma_rx_channel = dma_request_slave_channel(mmc_dev(host->mmc), "rx");
host->dma_tx_channel = dma_request_slave_channel(mmc_dev(host->mmc), "tx");
if (max_seg_size < host->mmc->max_seg_size)
host->mmc->max_seg_size = max_seg_size;
}
+
+ if (variant->qcom_dml && host->dma_rx_channel && host->dma_tx_channel)
+ if (dml_hw_init(host, host->mmc->parent->of_node))
+ variant->qcom_dml = false;
}
/*
struct dma_async_tx_descriptor *desc;
enum dma_data_direction buffer_dirn;
int nr_sg;
+ unsigned long flags = DMA_CTRL_ACK;
if (data->flags & MMC_DATA_READ) {
conf.direction = DMA_DEV_TO_MEM;
if (nr_sg == 0)
return -EINVAL;
+ if (host->variant->qcom_dml)
+ flags |= DMA_PREP_INTERRUPT;
+
dmaengine_slave_config(chan, &conf);
desc = dmaengine_prep_slave_sg(chan, data->sg, nr_sg,
- conf.direction, DMA_CTRL_ACK);
+ conf.direction, flags);
if (!desc)
goto unmap_exit;
dmaengine_submit(host->dma_desc_current);
dma_async_issue_pending(host->dma_current);
+ if (host->variant->qcom_dml)
+ dml_start_xfer(host, data);
+
datactrl |= MCI_DPSM_DMAENABLE;
/* Trigger the DMA transfer */
if (data->flags & MMC_DATA_READ)
datactrl |= MCI_DPSM_DIRECTION;
- /* The ST Micro variants has a special bit to enable SDIO */
if (variant->sdio && host->mmc->card)
if (mmc_card_sdio(host->mmc->card)) {
- /*
- * The ST Micro variants has a special bit
- * to enable SDIO.
- */
u32 clk;
-
- datactrl |= MCI_ST_DPSM_SDIOEN;
+ datactrl |= variant->datactrl_mask_sdio;
/*
* The ST Micro variant for SDIO small write transfers
writel(0, host->base + MMCIMASK1);
writel(0xfff, host->base + MMCICLEAR);
- /* If DT, cd/wp gpios must be supplied through it. */
- if (!np && gpio_is_valid(plat->gpio_cd)) {
- ret = mmc_gpio_request_cd(mmc, plat->gpio_cd, 0);
- if (ret)
- goto clk_disable;
- }
- if (!np && gpio_is_valid(plat->gpio_wp)) {
- ret = mmc_gpio_request_ro(mmc, plat->gpio_wp);
- if (ret)
- goto clk_disable;
+ /*
+ * If:
+ * - not using DT but using a descriptor table, or
+ * - using a table of descriptors ALONGSIDE DT, or
+ * look up these descriptors named "cd" and "wp" right here, fail
+ * silently of these do not exist and proceed to try platform data
+ */
+ if (!np) {
+ ret = mmc_gpiod_request_cd(mmc, "cd", 0, false, 0);
+ if (ret < 0) {
+ if (ret == -EPROBE_DEFER)
+ goto clk_disable;
+ else if (gpio_is_valid(plat->gpio_cd)) {
+ ret = mmc_gpio_request_cd(mmc, plat->gpio_cd, 0);
+ if (ret)
+ goto clk_disable;
+ }
+ }
+
+ ret = mmc_gpiod_request_ro(mmc, "wp", 0, false, 0);
+ if (ret < 0) {
+ if (ret == -EPROBE_DEFER)
+ goto clk_disable;
+ else if (gpio_is_valid(plat->gpio_wp)) {
+ ret = mmc_gpio_request_ro(mmc, plat->gpio_wp);
+ if (ret)
+ goto clk_disable;
+ }
+ }
}
ret = devm_request_irq(&dev->dev, dev->irq[0], mmci_irq, IRQF_SHARED,