if you want to specify device partitioning.
config MTD_BCM47XXSFLASH
- tristate "R/O support for serial flash on BCMA bus"
+ tristate "Support for serial flash on BCMA bus"
depends on BCMA_SFLASH && (MIPS || ARM)
help
BCMA bus can have various flash memories attached, they are
registered by bcma as platform devices. This enables driver for
- serial flash memories (only read-only mode is implemented).
+ serial flash memories.
config MTD_SLRAM
tristate "Uncached system RAM"
as a module, it is also possible to specify this as a parameter when
loading the module.
-#If not a module (I don't want to test it as a module)
-config MTDRAM_ABS_POS
- hex "SRAM Hexadecimal Absolute position or 0"
- depends on MTD_MTDRAM=y
- default "0"
- help
- If you have system RAM accessible by the CPU but not used by Linux
- in normal operation, you can give the physical address at which the
- available RAM starts, and the MTDRAM driver will use it instead of
- allocating space from Linux's available memory. Otherwise, leave
- this set to zero. Most people will want to leave this as zero.
-
config MTD_BLOCK2MTD
tristate "MTD using block device"
depends on BLOCK