dmascc. If you don't pass any parameter to the driver, all
possible I/O addresses are probed. This could irritate other devices
that are currently not in use. You may specify the list of addresses
- to be probed by "dmascc=addr1,addr2,..." (when compiled into the
+ to be probed by "dmascc.io=addr1,addr2,..." (when compiled into the
kernel image) or "io=addr1,addr2,..." (when loaded as a module). The
network interfaces will be called dmascc0 and dmascc1 for the board
detected first, dmascc2 and dmascc3 for the second one, and so on.
certain parameters, such as channel access timing, clock mode, and
DMA channel. This is accomplished with a small utility program,
dmascc_cfg, available at
- <http://cacofonix.nt.tuwien.ac.at/~oe1kib/Linux/>. Please be sure to
+ <http://www.linux-ax25.org/wiki/Ax25-tools>. Please be sure to
get at least version 1.27 of dmascc_cfg, as older versions will not
work with the current driver.
modems that connect to a serial interface. The driver supports the
ser12 design in half-duplex mode. This is the old driver. It is
still provided in case your serial interface chip does not work with
- the full-duplex driver. This driver is depreciated. To configure
+ the full-duplex driver. This driver is deprecated. To configure
the driver, use the sethdlc utility available in the standard ax25
utilities package. For information on the modems, see
<http://www.baycom.de/> and