/* If we are stopped or resetting exit gracefully and wait to be
* started again before accessing the hardware.
*/
- if(hw->adapter_stopped) {
+ if (hw->adapter_stopped) {
DEBUGOUT("Exiting because the adapter is already stopped!!!\n");
return false;
}
* hw - Struct containing variables accessed by shared code
*
* Places the MAC address in receive address register 0 and clears the rest
- * of the receive addresss registers. Clears the multicast table. Assumes
+ * of the receive address registers. Clears the multicast table. Assumes
* the receiver is in reset when the routine is called.
*****************************************************************************/
static void
/* Place this multicast address in the RAR if there is room, *
* else put it in the MTA
*/
- if(rar_used_count < IXGB_RAR_ENTRIES) {
+ if (rar_used_count < IXGB_RAR_ENTRIES) {
ixgb_rar_set(hw,
mc_addr_list +
(i * (IXGB_ETH_LENGTH_OF_ADDRESS + pad)),
/* Write the new settings */
IXGB_WRITE_REG(hw, CTRL0, ctrl_reg);
- if (pap_reg != 0) {
+ if (pap_reg != 0)
IXGB_WRITE_REG(hw, PAP, pap_reg);
- }
/* Set the flow control receive threshold registers. Normally,
* these registers will be set to a default threshold that may be
* ability to transmit pause frames in not enabled, then these
* registers will be set to 0.
*/
- if(!(hw->fc.type & ixgb_fc_tx_pause)) {
+ if (!(hw->fc.type & ixgb_fc_tx_pause)) {
IXGB_WRITE_REG(hw, FCRTL, 0);
IXGB_WRITE_REG(hw, FCRTH, 0);
} else {
/* We need to set up the Receive Threshold high and low water
* marks as well as (optionally) enabling the transmission of XON
* frames. */
- if(hw->fc.send_xon) {
+ if (hw->fc.send_xon) {
IXGB_WRITE_REG(hw, FCRTL,
(hw->fc.low_water | IXGB_FCRTL_XONE));
} else {
}
/******************************************************************************
- * Check for a bad link condition that may have occured.
+ * Check for a bad link condition that may have occurred.
* The indication is that the RFC / LFC registers may be incrementing
* continually. A full adapter reset is required to recover.
*
DEBUGFUNC("ixgb_clear_hw_cntrs");
/* if we are stopped or resetting exit gracefully */
- if(hw->adapter_stopped) {
+ if (hw->adapter_stopped) {
DEBUGOUT("Exiting because the adapter is stopped!!!\n");
return;
}