(vh->h_vlan_encapsulated_proto == htons(ETH_P_IP) ||
vh->h_vlan_encapsulated_proto == htons(ETH_P_IPV6))) {
skb->csum = hw_csum;
- skb->ip_summed = CHECKSUM_HW;
+ skb->ip_summed = CHECKSUM_COMPLETE;
}
}
if ((skb->protocol == ntohs(ETH_P_IP)) ||
(skb->protocol == ntohs(ETH_P_IPV6))) {
skb->csum = ntohs((u16) csum);
- skb->ip_summed = CHECKSUM_HW;
+ skb->ip_summed = CHECKSUM_COMPLETE;
} else
myri10ge_vlan_ip_csum(skb, ntohs((u16) csum));
}
return 1;
}
-static irqreturn_t myri10ge_intr(int irq, void *arg, struct pt_regs *regs)
+static irqreturn_t myri10ge_intr(int irq, void *arg)
{
struct myri10ge_priv *mgp = arg;
struct mcp_irq_data *stats = mgp->fw_stats;
return mgp->msg_enable;
}
-static struct ethtool_ops myri10ge_ethtool_ops = {
+static const struct ethtool_ops myri10ge_ethtool_ops = {
.get_settings = myri10ge_get_settings,
.get_drvinfo = myri10ge_get_drvinfo,
.get_coalesce = myri10ge_get_coalesce,
pseudo_hdr_offset = 0;
odd_flag = 0;
flags = (MXGEFW_FLAGS_NO_TSO | MXGEFW_FLAGS_FIRST);
- if (likely(skb->ip_summed == CHECKSUM_HW)) {
+ if (likely(skb->ip_summed == CHECKSUM_PARTIAL)) {
cksum_offset = (skb->h.raw - skb->data);
pseudo_hdr_offset = (skb->h.raw + skb->csum) - skb->data;
/* If the headers are excessively large, then we must
* fall back to a software checksum */
if (unlikely(cksum_offset > 255 || pseudo_hdr_offset > 127)) {
- if (skb_checksum_help(skb, 0))
+ if (skb_checksum_help(skb))
goto drop;
cksum_offset = 0;
pseudo_hdr_offset = 0;
* firmware image, and set tx.boundary to 4KB.
*/
-#define PCI_DEVICE_ID_SERVERWORKS_HT2000_PCIE 0x0132
+#define PCI_DEVICE_ID_INTEL_E5000_PCIE23 0x25f7
+#define PCI_DEVICE_ID_INTEL_E5000_PCIE47 0x25fa
static void myri10ge_select_firmware(struct myri10ge_priv *mgp)
{
mgp->fw_name = myri10ge_fw_unaligned;
if (myri10ge_force_firmware == 0) {
+ int link_width, exp_cap;
+ u16 lnk;
+
+ exp_cap = pci_find_capability(mgp->pdev, PCI_CAP_ID_EXP);
+ pci_read_config_word(mgp->pdev, exp_cap + PCI_EXP_LNKSTA, &lnk);
+ link_width = (lnk >> 4) & 0x3f;
+
myri10ge_enable_ecrc(mgp);
- /* Check to see if the upstream bridge is known to
- * provide aligned completions */
- if (bridge
- /* ServerWorks HT2000/HT1000 */
- && bridge->vendor == PCI_VENDOR_ID_SERVERWORKS
- && bridge->device ==
- PCI_DEVICE_ID_SERVERWORKS_HT2000_PCIE) {
+ /* Check to see if Link is less than 8 or if the
+ * upstream bridge is known to provide aligned
+ * completions */
+ if (link_width < 8) {
+ dev_info(&mgp->pdev->dev, "PCIE x%d Link\n",
+ link_width);
+ mgp->tx.boundary = 4096;
+ mgp->fw_name = myri10ge_fw_aligned;
+ } else if (bridge &&
+ /* ServerWorks HT2000/HT1000 */
+ ((bridge->vendor == PCI_VENDOR_ID_SERVERWORKS
+ && bridge->device ==
+ PCI_DEVICE_ID_SERVERWORKS_HT2000_PCIE)
+ /* All Intel E5000 PCIE ports */
+ || (bridge->vendor == PCI_VENDOR_ID_INTEL
+ && bridge->device >=
+ PCI_DEVICE_ID_INTEL_E5000_PCIE23
+ && bridge->device <=
+ PCI_DEVICE_ID_INTEL_E5000_PCIE47))) {
dev_info(&mgp->pdev->dev,
"Assuming aligned completions (0x%x:0x%x)\n",
bridge->vendor, bridge->device);
* This watchdog is used to check whether the board has suffered
* from a parity error and needs to be recovered.
*/
-static void myri10ge_watchdog(void *arg)
+static void myri10ge_watchdog(struct work_struct *work)
{
- struct myri10ge_priv *mgp = arg;
+ struct myri10ge_priv *mgp =
+ container_of(work, struct myri10ge_priv, watchdog_work);
u32 reboot;
int status;
u16 cmd, vendor;
(unsigned long)mgp);
SET_ETHTOOL_OPS(netdev, &myri10ge_ethtool_ops);
- INIT_WORK(&mgp->watchdog_work, myri10ge_watchdog, mgp);
+ INIT_WORK(&mgp->watchdog_work, myri10ge_watchdog);
status = register_netdev(netdev);
if (status != 0) {
dev_err(&pdev->dev, "register_netdev failed: %d\n", status);