# PHY Layer Configuration
#
-menu "PHY device support"
-
-config PHYLIB
+menuconfig PHYLIB
tristate "PHY Device support and infrastructure"
+ depends on !S390
depends on NET_ETHERNET && (BROKEN || !S390)
help
Ethernet controllers are usually attached to PHY
devices. This option provides infrastructure for
managing PHY devices.
+if PHYLIB
+
comment "MII PHY device drivers"
- depends on PHYLIB
config MARVELL_PHY
tristate "Drivers for Marvell PHYs"
- depends on PHYLIB
---help---
Currently has a driver for the 88E1011S
config DAVICOM_PHY
tristate "Drivers for Davicom PHYs"
- depends on PHYLIB
---help---
Currently supports dm9161e and dm9131
config QSEMI_PHY
tristate "Drivers for Quality Semiconductor PHYs"
- depends on PHYLIB
---help---
Currently supports the qs6612
config LXT_PHY
tristate "Drivers for the Intel LXT PHYs"
- depends on PHYLIB
---help---
Currently supports the lxt970, lxt971
config CICADA_PHY
tristate "Drivers for the Cicada PHYs"
- depends on PHYLIB
---help---
Currently supports the cis8204
+
config VITESSE_PHY
tristate "Drivers for the Vitesse PHYs"
- depends on PHYLIB
---help---
Currently supports the vsc8244
config SMSC_PHY
tristate "Drivers for SMSC PHYs"
- depends on PHYLIB
---help---
Currently supports the LAN83C185 PHY
config BROADCOM_PHY
tristate "Drivers for Broadcom PHYs"
- depends on PHYLIB
---help---
Currently supports the BCM5411, BCM5421 and BCM5461 PHYs.
+config ICPLUS_PHY
+ tristate "Drivers for ICPlus PHYs"
+ ---help---
+ Currently supports the IP175C PHY.
+
config FIXED_PHY
tristate "Drivers for PHY emulation on fixed speed/link"
- depends on PHYLIB
---help---
Adds the driver to PHY layer to cover the boards that do not have any PHY bound,
but with the ability to manipulate the speed/link in software. The relevant MII
bool "Emulation for 100M Fdx fixed PHY behavior"
depends on FIXED_PHY
-endmenu
+config FIXED_MII_1000_FDX
+ bool "Emulation for 1000M Fdx fixed PHY behavior"
+ depends on FIXED_PHY
+
+config FIXED_MII_AMNT
+ int "Number of emulated PHYs to allocate "
+ depends on FIXED_PHY
+ default "1"
+ ---help---
+ Sometimes it is required to have several independent emulated
+ PHYs on the bus (in case of multi-eth but phy-less HW for instance).
+ This control will have specified number allocated for each fixed
+ PHY type enabled.
+endif # PHYLIB