#define RPC_LSA_DEFAULT RPC_LED_100_10
#define RPC_LSB_DEFAULT RPC_LED_TX_RX
-#define SMC_DYNAMIC_BUS_CONFIG
#endif
spinlock_t lock;
-#ifdef SMC_USE_PXA_DMA
+#ifdef CONFIG_ARCH_PXA
/* DMA needs the physical address of the chip */
u_long physaddr;
struct device *device;
void __iomem *base;
void __iomem *datacs;
+ /* the low address lines on some platforms aren't connected... */
+ int io_shift;
+
struct smc91x_platdata cfg;
};
-#ifdef SMC_DYNAMIC_BUS_CONFIG
-#define SMC_8BIT(p) (((p)->cfg.flags & SMC91X_USE_8BIT) && SMC_CAN_USE_8BIT)
-#define SMC_16BIT(p) (((p)->cfg.flags & SMC91X_USE_16BIT) && SMC_CAN_USE_16BIT)
-#define SMC_32BIT(p) (((p)->cfg.flags & SMC91X_USE_32BIT) && SMC_CAN_USE_32BIT)
-#else
-#define SMC_8BIT(p) SMC_CAN_USE_8BIT
-#define SMC_16BIT(p) SMC_CAN_USE_16BIT
-#define SMC_32BIT(p) SMC_CAN_USE_32BIT
-#endif
+#define SMC_8BIT(p) ((p)->cfg.flags & SMC91X_USE_8BIT)
+#define SMC_16BIT(p) ((p)->cfg.flags & SMC91X_USE_16BIT)
+#define SMC_32BIT(p) ((p)->cfg.flags & SMC91X_USE_32BIT)
-#ifdef SMC_USE_PXA_DMA
+#ifdef CONFIG_ARCH_PXA
/*
* Let's use the DMA engine on the XScale PXA2xx for RX packets. This is
* always happening in irq context so no need to worry about races. TX is
{
DCSR(dma) = 0;
}
-#endif /* SMC_USE_PXA_DMA */
+#endif /* CONFIG_ARCH_PXA */
/*