#include "iwl-power.h"
#include "iwl-agn-rs.h"
#include "iwl-agn-tt.h"
-#include "iwl-bus.h"
#include "iwl-trans.h"
#include "iwl-shared.h"
+#include "iwl-op-mode.h"
struct iwl_tx_queue;
u8 state;
};
-#define EEPROM_SEM_TIMEOUT 10 /* milliseconds */
-#define EEPROM_SEM_RETRY_LIMIT 1000 /* number of attempts (not time) */
-
enum {
MEASUREMENT_READY = (1 << 0),
MEASUREMENT_ACTIVE = (1 << 1),
u8 extension_chan_offset;
} ht;
- u8 bssid[ETH_ALEN];
- bool preauth_bssid;
-
bool last_tx_rejected;
};
u8 data[];
};
+#define IWL_OP_MODE_GET_DVM(_iwl_op_mode) \
+ ((struct iwl_priv *) ((_iwl_op_mode)->op_mode_specific))
+
+#define IWL_MAC80211_GET_DVM(_hw) \
+ ((struct iwl_priv *) ((struct iwl_op_mode *) \
+ (_hw)->priv)->op_mode_specific)
+
struct iwl_priv {
/*data shared among all the driver's layers */
struct iwl_shared *shrd;
+ spinlock_t sta_lock;
+
/* ieee device used by generic ieee processing code */
struct ieee80211_hw *hw;
struct ieee80211_channel *ieee_channels;
struct ieee80211_rate *ieee_rates;
struct kmem_cache *tx_cmd_pool;
+ struct workqueue_struct *workqueue;
+
enum ieee80211_band band;
void (*pre_rx_handler)(struct iwl_priv *priv,
- struct iwl_rx_mem_buffer *rxb);
+ struct iwl_rx_cmd_buffer *rxb);
int (*rx_handlers[REPLY_MAX])(struct iwl_priv *priv,
- struct iwl_rx_mem_buffer *rxb,
+ struct iwl_rx_cmd_buffer *rxb,
struct iwl_device_cmd *cmd);
struct ieee80211_supported_band bands[IEEE80211_NUM_BANDS];
bool new_scan_threshold_behaviour;
+ bool wowlan;
+
/* EEPROM MAC addresses */
struct mac_address addresses[2];
- /* uCode images, save to reload in case of failure */
- int fw_index; /* firmware we're trying to load */
- u32 ucode_ver; /* version of ucode, copy of
- iwl_ucode.ver */
-
- char firmware_name[25];
-
struct iwl_rxon_context contexts[NUM_IWL_RXON_CTX];
__le16 switch_channel;
u8 start_calib;
struct iwl_sensitivity_data sensitivity_data;
struct iwl_chain_noise_data chain_noise_data;
- bool enhance_sensitivity_table;
__le16 sensitivity_tbl[HD_TABLE_SIZE];
__le16 enhance_sensitivity_tbl[ENHANCE_HD_TABLE_ENTRIES];
struct statistics_bt_activity bt_activity;
__le32 num_bt_kills, accum_num_bt_kills;
#endif
+ spinlock_t lock;
} statistics;
#ifdef CONFIG_IWLWIFI_DEBUGFS
struct {
struct iwl_rx_phy_res last_phy_res;
bool last_phy_res_valid;
- struct completion firmware_loading_complete;
-
- u32 init_evtlog_ptr, init_evtlog_size, init_errlog_ptr;
- u32 inst_evtlog_ptr, inst_evtlog_size, inst_errlog_ptr;
-
/*
* chain noise reset and gain commands are the
* two extra calibration commands follows the standard