/**
* struct iwl_hcmd_dataflag - flag for each one of the chunks of the command
*
- * IWL_HCMD_DFL_NOCOPY: By default, the command is copied to the host command's
+ * @IWL_HCMD_DFL_NOCOPY: By default, the command is copied to the host command's
* ring. The transport layer doesn't map the command's buffer to DMA, but
* rather copies it to an previously allocated DMA buffer. This flag tells
* the transport layer not to copy the command, but to map the existing
- * buffer. This can save memcpy and is worth with very big comamnds.
+ * buffer (that is passed in) instead. This saves the memcpy and allows
+ * commands that are bigger than the fixed buffer to be submitted.
+ * Note that a TFD entry after a NOCOPY one cannot be a normal copied one.
+ * @IWL_HCMD_DFL_DUP: Only valid without NOCOPY, duplicate the memory for this
+ * chunk internally and free it again after the command completes. This
+ * can (currently) be used only once per command.
+ * Note that a TFD entry after a DUP one cannot be a normal copied one.
*/
enum iwl_hcmd_dataflag {
IWL_HCMD_DFL_NOCOPY = BIT(0),
+ IWL_HCMD_DFL_DUP = BIT(1),
};
/**
* @start_fw: allocates and inits all the resources for the transport
* layer. Also kick a fw image.
* May sleep
- * @fw_alive: called when the fw sends alive notification
+ * @fw_alive: called when the fw sends alive notification. If the fw provides
+ * the SCD base address in SRAM, then provide it here, or 0 otherwise.
* May sleep
* @stop_device:stops the whole device (embedded CPU put to reset)
* May sleep
* @wowlan_suspend: put the device into the correct mode for WoWLAN during
* suspend. This is optional, if not implemented WoWLAN will not be
* supported. This callback may sleep.
- * @send_cmd:send a host command
+ * @send_cmd:send a host command. Must return -ERFKILL if RFkill is asserted.
+ * If RFkill is asserted in the middle of a SYNC host command, it must
+ * return -ERFKILL straight away.
* May sleep only if CMD_SYNC is set
* @tx: send an skb
* Must be atomic
int (*start_hw)(struct iwl_trans *iwl_trans);
void (*stop_hw)(struct iwl_trans *iwl_trans, bool op_mode_leaving);
int (*start_fw)(struct iwl_trans *trans, const struct fw_img *fw);
- void (*fw_alive)(struct iwl_trans *trans);
+ void (*fw_alive)(struct iwl_trans *trans, u32 scd_addr);
void (*stop_device)(struct iwl_trans *trans);
void (*wowlan_suspend)(struct iwl_trans *trans);
* Set during transport allocation.
* @hw_id_str: a string with info about HW ID. Set during transport allocation.
* @pm_support: set to true in start_hw if link pm is supported
- * @wait_command_queue: the wait_queue for SYNC host commands
* @dev_cmd_pool: pool for Tx cmd allocation - for internal use only.
* The user should use iwl_trans_{alloc,free}_tx_cmd.
* @dev_cmd_headroom: room needed for the transport's private use before the
* device_cmd for Tx - for internal use only
* The user should use iwl_trans_{alloc,free}_tx_cmd.
+ * @rx_mpdu_cmd: MPDU RX command ID, must be assigned by opmode before
+ * starting the firmware, used for tracing
+ * @rx_mpdu_cmd_hdr_size: used for tracing, amount of data before the
+ * start of the 802.11 header in the @rx_mpdu_cmd
*/
struct iwl_trans {
const struct iwl_trans_ops *ops;
u32 hw_id;
char hw_id_str[52];
- bool pm_support;
+ u8 rx_mpdu_cmd, rx_mpdu_cmd_hdr_size;
- wait_queue_head_t wait_command_queue;
+ bool pm_support;
/* The following fields are internal only */
struct kmem_cache *dev_cmd_pool;
trans->state = IWL_TRANS_NO_FW;
}
-static inline void iwl_trans_fw_alive(struct iwl_trans *trans)
+static inline void iwl_trans_fw_alive(struct iwl_trans *trans, u32 scd_addr)
{
might_sleep();
trans->state = IWL_TRANS_FW_ALIVE;
- trans->ops->fw_alive(trans);
+ trans->ops->fw_alive(trans, scd_addr);
}
static inline int iwl_trans_start_fw(struct iwl_trans *trans,
{
might_sleep();
+ WARN_ON_ONCE(!trans->rx_mpdu_cmd);
+
return trans->ops->start_fw(trans, fw);
}