return inb(ap->ioaddr.altstatus_addr);
}
+/**
+ * ata_bmdma_setup_mmio - Set up PCI IDE BMDMA transaction
+ * @qc: Info associated with this ATA transaction.
+ *
+ * LOCKING:
+ * spin_lock_irqsave(host_set lock)
+ */
+
+static void ata_bmdma_setup_mmio (struct ata_queued_cmd *qc)
+{
+ struct ata_port *ap = qc->ap;
+ unsigned int rw = (qc->tf.flags & ATA_TFLAG_WRITE);
+ u8 dmactl;
+ void __iomem *mmio = (void __iomem *) ap->ioaddr.bmdma_addr;
+
+ /* load PRD table addr. */
+ mb(); /* make sure PRD table writes are visible to controller */
+ writel(ap->prd_dma, mmio + ATA_DMA_TABLE_OFS);
+
+ /* specify data direction, triple-check start bit is clear */
+ dmactl = readb(mmio + ATA_DMA_CMD);
+ dmactl &= ~(ATA_DMA_WR | ATA_DMA_START);
+ if (!rw)
+ dmactl |= ATA_DMA_WR;
+ writeb(dmactl, mmio + ATA_DMA_CMD);
+
+ /* issue r/w command */
+ ap->ops->exec_command(ap, &qc->tf);
+}
+
+/**
+ * ata_bmdma_start_mmio - Start a PCI IDE BMDMA transaction
+ * @qc: Info associated with this ATA transaction.
+ *
+ * LOCKING:
+ * spin_lock_irqsave(host_set lock)
+ */
+
+static void ata_bmdma_start_mmio (struct ata_queued_cmd *qc)
+{
+ struct ata_port *ap = qc->ap;
+ void __iomem *mmio = (void __iomem *) ap->ioaddr.bmdma_addr;
+ u8 dmactl;
+
+ /* start host DMA transaction */
+ dmactl = readb(mmio + ATA_DMA_CMD);
+ writeb(dmactl | ATA_DMA_START, mmio + ATA_DMA_CMD);
+
+ /* Strictly, one may wish to issue a readb() here, to
+ * flush the mmio write. However, control also passes
+ * to the hardware at this point, and it will interrupt
+ * us when we are to resume control. So, in effect,
+ * we don't care when the mmio write flushes.
+ * Further, a read of the DMA status register _immediately_
+ * following the write may not be what certain flaky hardware
+ * is expected, so I think it is best to not add a readb()
+ * without first all the MMIO ATA cards/mobos.
+ * Or maybe I'm just being paranoid.
+ */
+}
+
+/**
+ * ata_bmdma_setup_pio - Set up PCI IDE BMDMA transaction (PIO)
+ * @qc: Info associated with this ATA transaction.
+ *
+ * LOCKING:
+ * spin_lock_irqsave(host_set lock)
+ */
+
+static void ata_bmdma_setup_pio (struct ata_queued_cmd *qc)
+{
+ struct ata_port *ap = qc->ap;
+ unsigned int rw = (qc->tf.flags & ATA_TFLAG_WRITE);
+ u8 dmactl;
+
+ /* load PRD table addr. */
+ outl(ap->prd_dma, ap->ioaddr.bmdma_addr + ATA_DMA_TABLE_OFS);
+
+ /* specify data direction, triple-check start bit is clear */
+ dmactl = inb(ap->ioaddr.bmdma_addr + ATA_DMA_CMD);
+ dmactl &= ~(ATA_DMA_WR | ATA_DMA_START);
+ if (!rw)
+ dmactl |= ATA_DMA_WR;
+ outb(dmactl, ap->ioaddr.bmdma_addr + ATA_DMA_CMD);
+
+ /* issue r/w command */
+ ap->ops->exec_command(ap, &qc->tf);
+}
+
+/**
+ * ata_bmdma_start_pio - Start a PCI IDE BMDMA transaction (PIO)
+ * @qc: Info associated with this ATA transaction.
+ *
+ * LOCKING:
+ * spin_lock_irqsave(host_set lock)
+ */
+
+static void ata_bmdma_start_pio (struct ata_queued_cmd *qc)
+{
+ struct ata_port *ap = qc->ap;
+ u8 dmactl;
+
+ /* start host DMA transaction */
+ dmactl = inb(ap->ioaddr.bmdma_addr + ATA_DMA_CMD);
+ outb(dmactl | ATA_DMA_START,
+ ap->ioaddr.bmdma_addr + ATA_DMA_CMD);
+}
+
+
+/**
+ * ata_bmdma_start - Start a PCI IDE BMDMA transaction
+ * @qc: Info associated with this ATA transaction.
+ *
+ * Writes the ATA_DMA_START flag to the DMA command register.
+ *
+ * May be used as the bmdma_start() entry in ata_port_operations.
+ *
+ * LOCKING:
+ * spin_lock_irqsave(host_set lock)
+ */
+void ata_bmdma_start(struct ata_queued_cmd *qc)
+{
+ if (qc->ap->flags & ATA_FLAG_MMIO)
+ ata_bmdma_start_mmio(qc);
+ else
+ ata_bmdma_start_pio(qc);
+}
+
+
+/**
+ * ata_bmdma_setup - Set up PCI IDE BMDMA transaction
+ * @qc: Info associated with this ATA transaction.
+ *
+ * Writes address of PRD table to device's PRD Table Address
+ * register, sets the DMA control register, and calls
+ * ops->exec_command() to start the transfer.
+ *
+ * May be used as the bmdma_setup() entry in ata_port_operations.
+ *
+ * LOCKING:
+ * spin_lock_irqsave(host_set lock)
+ */
+void ata_bmdma_setup(struct ata_queued_cmd *qc)
+{
+ if (qc->ap->flags & ATA_FLAG_MMIO)
+ ata_bmdma_setup_mmio(qc);
+ else
+ ata_bmdma_setup_pio(qc);
+}
+
+
+/**
+ * ata_bmdma_irq_clear - Clear PCI IDE BMDMA interrupt.
+ * @ap: Port associated with this ATA transaction.
+ *
+ * Clear interrupt and error flags in DMA status register.
+ *
+ * May be used as the irq_clear() entry in ata_port_operations.
+ *
+ * LOCKING:
+ * spin_lock_irqsave(host_set lock)
+ */
+
+void ata_bmdma_irq_clear(struct ata_port *ap)
+{
+ if (!ap->ioaddr.bmdma_addr)
+ return;
+
+ if (ap->flags & ATA_FLAG_MMIO) {
+ void __iomem *mmio =
+ ((void __iomem *) ap->ioaddr.bmdma_addr) + ATA_DMA_STATUS;
+ writeb(readb(mmio), mmio);
+ } else {
+ unsigned long addr = ap->ioaddr.bmdma_addr + ATA_DMA_STATUS;
+ outb(inb(addr), addr);
+ }
+}
+
+
+/**
+ * ata_bmdma_status - Read PCI IDE BMDMA status
+ * @ap: Port associated with this ATA transaction.
+ *
+ * Read and return BMDMA status register.
+ *
+ * May be used as the bmdma_status() entry in ata_port_operations.
+ *
+ * LOCKING:
+ * spin_lock_irqsave(host_set lock)
+ */
+
+u8 ata_bmdma_status(struct ata_port *ap)
+{
+ u8 host_stat;
+ if (ap->flags & ATA_FLAG_MMIO) {
+ void __iomem *mmio = (void __iomem *) ap->ioaddr.bmdma_addr;
+ host_stat = readb(mmio + ATA_DMA_STATUS);
+ } else
+ host_stat = inb(ap->ioaddr.bmdma_addr + ATA_DMA_STATUS);
+ return host_stat;
+}
+
+
+/**
+ * ata_bmdma_stop - Stop PCI IDE BMDMA transfer
+ * @qc: Command we are ending DMA for
+ *
+ * Clears the ATA_DMA_START flag in the dma control register
+ *
+ * May be used as the bmdma_stop() entry in ata_port_operations.
+ *
+ * LOCKING:
+ * spin_lock_irqsave(host_set lock)
+ */
+
+void ata_bmdma_stop(struct ata_queued_cmd *qc)
+{
+ struct ata_port *ap = qc->ap;
+ if (ap->flags & ATA_FLAG_MMIO) {
+ void __iomem *mmio = (void __iomem *) ap->ioaddr.bmdma_addr;
+
+ /* clear start/stop bit */
+ writeb(readb(mmio + ATA_DMA_CMD) & ~ATA_DMA_START,
+ mmio + ATA_DMA_CMD);
+ } else {
+ /* clear start/stop bit */
+ outb(inb(ap->ioaddr.bmdma_addr + ATA_DMA_CMD) & ~ATA_DMA_START,
+ ap->ioaddr.bmdma_addr + ATA_DMA_CMD);
+ }
+
+ /* one-PIO-cycle guaranteed wait, per spec, for HDMA1:0 transition */
+ ata_altstatus(ap); /* dummy read */
+}
+
#ifdef CONFIG_PCI
static struct ata_probe_ent *
ata_probe_ent_alloc(struct device *dev, const struct ata_port_info *port)
projects / deliverable / linux.git / blobdiff