select SERIAL_CORE
help
Support for the on-chip UARTs on the NVIDIA Tegra series SOCs
- providing /dev/ttyHS0, 1, 2, 3 and 4 (note, some machines may not
+ providing /dev/ttyTHS0, 1, 2, 3 and 4 (note, some machines may not
provide all of these ports, depending on how the serial port
are enabled). This driver uses the APB DMA to achieve higher baudrate
and better performance.
config SERIAL_MAX310X
bool "MAX310X support"
- depends on SPI
+ depends on SPI_MASTER
select SERIAL_CORE
- select REGMAP_SPI if SPI
+ select REGMAP_SPI if SPI_MASTER
default n
help
This selects support for an advanced UART from Maxim (Dallas).
- Supported ICs are MAX3107, MAX3108.
+ Supported ICs are MAX3107, MAX3108, MAX3109, MAX14830.
Each IC contains 128 words each of receive and transmit FIFO
that can be controlled through I2C or high-speed SPI.
config SERIAL_AR933X
bool "AR933X serial port support"
- depends on SOC_AR933X
+ depends on HAVE_CLK && SOC_AR933X
select SERIAL_CORE
help
If you have an Atheros AR933X SOC based board and want to use the
to support.
config SERIAL_EFM32_UART
- tristate "EFM32 UART/USART port."
- depends on ARCH_EFM32
+ tristate "EFM32 UART/USART port"
+ depends on ARM && (ARCH_EFM32 || COMPILE_TEST)
select SERIAL_CORE
help
This driver support the USART and UART ports on
If you have enabled the lpuart serial port on the Freescale SoCs,
you can make it the console by answering Y to this option.
+config SERIAL_ST_ASC
+ tristate "ST ASC serial port support"
+ select SERIAL_CORE
+ help
+ This driver is for the on-chip Asychronous Serial Controller on
+ STMicroelectronics STi SoCs.
+ ASC is embedded in ST COMMS IP block. It supports Rx & Tx functionality.
+ It support all industry standard baud rates.
+
+ If unsure, say N.
+
+config SERIAL_ST_ASC_CONSOLE
+ bool "Support for console on ST ASC"
+ depends on SERIAL_ST_ASC=y
+ select SERIAL_CORE_CONSOLE
+
endmenu
endif # TTY