unsigned iddig:5;
unsigned iddig_mux:5;
/* miscellaneous stuff */
- u8 poll_seconds;
+ unsigned poll_timeout;
};
/*
dsps_writel(reg_base, wrp->epintr_set, epmask);
dsps_writel(reg_base, wrp->coreintr_set, coremask);
- /* Force the DRVVBUS IRQ so we can start polling for ID change. */
- dsps_writel(reg_base, wrp->coreintr_set,
- (1 << wrp->drvvbus) << wrp->usb_shift);
+ /* start polling for ID change. */
+ mod_timer(&glue->timer, jiffies + msecs_to_jiffies(wrp->poll_timeout));
dsps_musb_try_idle(musb, 0);
}
}
if (!(devctl & MUSB_DEVCTL_SESSION) && !skip_session)
dsps_writeb(mregs, MUSB_DEVCTL, MUSB_DEVCTL_SESSION);
- mod_timer(&glue->timer, jiffies + wrp->poll_seconds * HZ);
+ mod_timer(&glue->timer, jiffies +
+ msecs_to_jiffies(wrp->poll_timeout));
break;
case OTG_STATE_A_WAIT_VFALL:
musb->xceiv->otg->state = OTG_STATE_A_WAIT_VRISE;
dev_dbg(musb->controller, "usbintr (%x) epintr(%x)\n",
usbintr, epintr);
- /*
- * DRVVBUS IRQs are the only proxy we have (a very poor one!) for
- * DSPS IP's missing ID change IRQ. We need an ID change IRQ to
- * switch appropriately between halves of the OTG state machine.
- * Managing DEVCTL.SESSION per Mentor docs requires that we know its
- * value but DEVCTL.BDEVICE is invalid without DEVCTL.SESSION set.
- * Also, DRVVBUS pulses for SRP (but not at 5V) ...
- */
- if (is_host_active(musb) && usbintr & MUSB_INTR_BABBLE) {
- pr_info("CAUTION: musb: Babble Interrupt Occurred\n");
-
- /*
- * When a babble condition occurs, the musb controller removes
- * the session and is no longer in host mode. Hence, all
- * devices connected to its root hub get disconnected.
- *
- * Hand this error down to the musb core isr, so it can
- * recover.
- */
- musb->int_usb = MUSB_INTR_BABBLE | MUSB_INTR_DISCONNECT;
- musb->int_tx = musb->int_rx = 0;
- }
if (usbintr & ((1 << wrp->drvvbus) << wrp->usb_shift)) {
int drvvbus = dsps_readl(reg_base, wrp->status);
*/
musb->int_usb &= ~MUSB_INTR_VBUSERROR;
musb->xceiv->otg->state = OTG_STATE_A_WAIT_VFALL;
- mod_timer(&glue->timer,
- jiffies + wrp->poll_seconds * HZ);
+ mod_timer(&glue->timer, jiffies +
+ msecs_to_jiffies(wrp->poll_timeout));
WARNING("VBUS error workaround (delay coming)\n");
} else if (drvvbus) {
MUSB_HST_MODE(musb);
/* Poll for ID change in OTG port mode */
if (musb->xceiv->otg->state == OTG_STATE_B_IDLE &&
musb->port_mode == MUSB_PORT_MODE_DUAL_ROLE)
- mod_timer(&glue->timer, jiffies + wrp->poll_seconds * HZ);
+ mod_timer(&glue->timer, jiffies +
+ msecs_to_jiffies(wrp->poll_timeout));
out:
spin_unlock_irqrestore(&musb->lock, flags);
musb->ctrl_base = reg_base;
/* NOP driver needs change if supporting dual instance */
- musb->xceiv = devm_usb_get_phy_by_phandle(dev, "phys", 0);
+ musb->xceiv = devm_usb_get_phy_by_phandle(dev->parent, "phys", 0);
if (IS_ERR(musb->xceiv))
return PTR_ERR(musb->xceiv);
* logic enabled.
*/
val = dsps_readb(musb->mregs, MUSB_BABBLE_CTL);
- if (val == MUSB_BABBLE_RCV_DISABLE) {
+ if (val & MUSB_BABBLE_RCV_DISABLE) {
glue->sw_babble_enabled = true;
val |= MUSB_BABBLE_SW_SESSION_CTRL;
dsps_writeb(musb->mregs, MUSB_BABBLE_CTL, val);
return 0;
}
-static bool sw_babble_control(struct musb *musb)
+static bool dsps_sw_babble_control(struct musb *musb)
{
u8 babble_ctl;
bool session_restart = false;
return session_restart;
}
-static int dsps_musb_reset(struct musb *musb)
+static int dsps_musb_recover(struct musb *musb)
{
struct device *dev = musb->controller;
struct dsps_glue *glue = dev_get_drvdata(dev->parent);
- const struct dsps_musb_wrapper *wrp = glue->wrp;
- int session_restart = 0, error;
+ int session_restart = 0;
if (glue->sw_babble_enabled)
- session_restart = sw_babble_control(musb);
- /*
- * In case of new silicon version babble condition can be recovered
- * without resetting the MUSB. But for older silicon versions, MUSB
- * reset is needed
- */
- if (session_restart || !glue->sw_babble_enabled) {
- dev_info(musb->controller, "Restarting MUSB to recover from Babble\n");
- dsps_writel(musb->ctrl_base, wrp->control, (1 << wrp->reset));
- usleep_range(100, 200);
- usb_phy_shutdown(musb->xceiv);
- error = phy_power_off(musb->phy);
- if (error)
- dev_err(dev, "phy shutdown failed: %i\n", error);
- usleep_range(100, 200);
- usb_phy_init(musb->xceiv);
- error = phy_power_on(musb->phy);
- if (error)
- dev_err(dev, "phy powerup failed: %i\n", error);
+ session_restart = dsps_sw_babble_control(musb);
+ else
session_restart = 1;
+
+ return session_restart ? 0 : -EPIPE;
+}
+
+/* Similar to am35x, dm81xx support only 32-bit read operation */
+static void dsps_read_fifo32(struct musb_hw_ep *hw_ep, u16 len, u8 *dst)
+{
+ void __iomem *fifo = hw_ep->fifo;
+
+ if (len >= 4) {
+ ioread32_rep(fifo, dst, len >> 2);
+ dst += len & ~0x03;
+ len &= 0x03;
}
- return !session_restart;
+ /* Read any remaining 1 to 3 bytes */
+ if (len > 0) {
+ u32 val = musb_readl(fifo, 0);
+ memcpy(dst, &val, len);
+ }
}
static struct musb_platform_ops dsps_ops = {
.try_idle = dsps_musb_try_idle,
.set_mode = dsps_musb_set_mode,
- .reset = dsps_musb_reset,
+ .recover = dsps_musb_recover,
};
static u64 musb_dmamask = DMA_BIT_MASK(32);
musb->dev.parent = dev;
musb->dev.dma_mask = &musb_dmamask;
musb->dev.coherent_dma_mask = musb_dmamask;
- musb->dev.of_node = of_node_get(dn);
glue->musb = musb;
}
wrp = match->data;
+ if (of_device_is_compatible(pdev->dev.of_node, "ti,musb-dm816"))
+ dsps_ops.read_fifo = dsps_read_fifo32;
+
/* allocate glue */
glue = devm_kzalloc(&pdev->dev, sizeof(*glue), GFP_KERNEL);
if (!glue)
.rxep_shift = 16,
.rxep_mask = 0xfffe,
.rxep_bitmap = (0xfffe << 16),
- .poll_seconds = 2,
+ .poll_timeout = 2000, /* ms */
};
static const struct of_device_id musb_dsps_of_match[] = {
{ .compatible = "ti,musb-am33xx",
- .data = (void *) &am33xx_driver_data, },
+ .data = &am33xx_driver_data, },
+ { .compatible = "ti,musb-dm816",
+ .data = &am33xx_driver_data, },
{ },
};
MODULE_DEVICE_TABLE(of, musb_dsps_of_match);
dsps_writel(mbase, wrp->rx_mode, glue->context.rx_mode);
if (musb->xceiv->otg->state == OTG_STATE_B_IDLE &&
musb->port_mode == MUSB_PORT_MODE_DUAL_ROLE)
- mod_timer(&glue->timer, jiffies + wrp->poll_seconds * HZ);
+ mod_timer(&glue->timer, jiffies +
+ msecs_to_jiffies(wrp->poll_timeout));
return 0;
}
projects / deliverable / linux.git / blobdiff