one(s) there should be removed when we have to step over one. Support
breakpoints that don't have to be removed to step over them.
-Speed up watchpoints by not single-stepping them, but do something
-faster like single-line execution. Speed them up tremendously on
-machines that have watchpoint registers.
+Speed up watchpoints by using debug registers, page table diddling (on
+SunOS4, can call mprotect() in the inferior; on other machines can do
+something simpler), etc.
Update gdbint.texinfo to include doc on the directory structure and
the various tricks of building gdb.
unpack_double() does not handle IEEE float on the target unless the host
is also IEEE. Death on a vax.
-Test cross-debugging Unix-to-Unix.
-
-Check the RAPP remote protocol. What is it? It's in Makefile.in
-and one ChangeLog entry.
-
Set up interface between GDB and INFO so that you can hop into interactive
INFO and back out again. When running under Emacs, should use Emacs
info, else fork the info program. Installation of GDB should install
call functions in the child, and while there, the child is interrupted
with a signal, or hits a breakpoint.)
-Symbol completion with TAB does not unmangle names!
-
help completion, help history should work.
-Symbol completion doesn't handle e.g. W::f. (symtab.c,
-make_symbol_completion_list).
-
Check that we can handle stack trace through varargs AND alloca in same
function, on 29K.
"i frame" shows wrong "arglist at" location, doesn't show where the args
should be found, only their actual values.
-Symbolic display of addrs, (& disassembly prefixes), don't show static
-fns, e.g. enable_command in gdb.
-
-'ptype yylval' ==> "union YYSTYPE { ..... }". However, it is not a
-union YYSTYPE, but is simply a YYSTYPE, which is a typedef for an
-unnamed union.
-
There should be a way for "set" commands to validate the new setting
before it takes effect.
should end up coming back the same (modulo transformation comments)
if fed to "gas" then the .o is fed to gdb for disassembly.
-Merge the xxx-opcode.h files with gas again...
-
Eliminate all the core_file_command's in all the xdep files.
Eliminate separate declarations of registers[] everywhere.
Line numbers are off in some spots. In proceed() at 1st "oneproc = 1",
it seems to run that statement, but it doesn't actually.
-Perhaps move the tdep and xdep files, and the tm and xm files, into a config
-subdirectory. If not, at least straighten out their names so that
+Perhaps move the tdep, xdep, and nat files, into the config
+subdirectories. If not, at least straighten out their names so that
they all start with the machine name.
inferior_status should include stop_print_frame. It won't need to be