the request itself succeeds or fails. */
mips_request ('r', 0, 0, &err, mips_receive_wait, NULL);
- set_current_frame (create_new_frame (read_fp (), read_pc ()));
- select_frame (get_current_frame ());
+ /* FIXME: cagney/2002-11-29: Force the update of selected frame.
+ This shouldn't be necessary, only many many places still refer to
+ selected_frame directly (instead of using get_selected_frame(). */
+ get_selected_frame (); /* Hack!!! */
}
/* Open a connection to the remote board. */
if (ptype)
mips_set_processor_type_command (xstrdup (ptype), 0);
-/* This is really the job of start_remote however, that makes an assumption
- that the target is about to print out a status message of some sort. That
- doesn't happen here (in fact, it may not be possible to get the monitor to
- send the appropriate packet). */
+ /* This is really the job of start_remote however, that makes an
+ assumption that the target is about to print out a status message
+ of some sort. That doesn't happen here (in fact, it may not be
+ possible to get the monitor to send the appropriate packet). */
flush_cached_frames ();
registers_changed ();
stop_pc = read_pc ();
- set_current_frame (create_new_frame (read_fp (), stop_pc));
- select_frame (get_current_frame ());
- print_stack_frame (selected_frame, -1, 1);
+ print_stack_frame (get_selected_frame (), -1, 1);
xfree (serial_port_name);
}
/* Work around problem where PMON monitor updates the PC after a load
to a different value than GDB thinks it has. The following ensures
that the write_pc() WILL update the PC value: */
- register_valid[PC_REGNUM] = 0;
+ deprecated_register_valid[PC_REGNUM] = 0;
}
if (exec_bfd)
write_pc (bfd_get_start_address (exec_bfd));