Fix ARI warnings about new lines at the end of messages, which

[deliverable/binutils-gdb.git] / gdb / remote-mips.c

diff --git a/gdb/remote-mips.c b/gdb/remote-mips.c
index bc82bc8c5145fbcaa596917f1a4d567ceb4f5701..8f96945318cb6b344c5375d956ca131361dfbd44 100644 (file)
--- a/gdb/remote-mips.c
+++ b/gdb/remote-mips.c
@@ -672,13 +672,13 @@ mips_readchar (int timeout)
   if (ch == SERIAL_TIMEOUT && timeout == -1)   /* Watchdog went off.  */
     {
       target_mourn_inferior ();
-      error ("Watchdog has expired.  Target detached.\n");
+      error (_("Watchdog has expired.  Target detached."));
     }
 
   if (ch == SERIAL_EOF)
-    mips_error ("End of file from remote");
+    mips_error (_("End of file from remote"));
   if (ch == SERIAL_ERROR)
-    mips_error ("Error reading from remote: %s", safe_strerror (errno));
+    mips_error (_("Error reading from remote: %s"), safe_strerror (errno));
   if (remote_debug > 1)
     {
       /* Don't use _filtered; we can't deal with a QUIT out of
@@ -713,7 +713,7 @@ mips_readchar (int timeout)
       /* At this point, about the only thing we can do is abort the command
          in progress and get back to command level as quickly as possible.  */
 
-      error ("Remote board reset, debug protocol re-initialized.");
+      error (_("Remote board reset, debug protocol re-initialized."));
     }
 
   if (ch == mips_monitor_prompt[state])
@@ -771,8 +771,8 @@ mips_receive_header (unsigned char *hdr, int *pgarbage, int ch, int timeout)
 
              if (mips_syn_garbage > 0
                  && *pgarbage > mips_syn_garbage)
-               mips_error ("Debug protocol failure:  more "
-                           "than %d characters before a sync.",
+               mips_error (_("Debug protocol failure:  more "
+                           "than %d characters before a sync."),
                            mips_syn_garbage);
            }
        }
@@ -860,7 +860,7 @@ mips_send_packet (const char *s, int get_ack)
 
   len = strlen (s);
   if (len > DATA_MAXLEN)
-    mips_error ("MIPS protocol data packet too long: %s", s);
+    mips_error (_("MIPS protocol data packet too long: %s"), s);
 
   packet = (unsigned char *) alloca (HDR_LENGTH + len + TRLR_LENGTH + 1);
 
@@ -898,7 +898,7 @@ mips_send_packet (const char *s, int get_ack)
 
       if (serial_write (mips_desc, packet,
                        HDR_LENGTH + len + TRLR_LENGTH) != 0)
-       mips_error ("write to target failed: %s", safe_strerror (errno));
+       mips_error (_("write to target failed: %s"), safe_strerror (errno));
 
       if (!get_ack)
        return;
@@ -1006,7 +1006,7 @@ mips_send_packet (const char *s, int get_ack)
        }
     }
 
-  mips_error ("Remote did not acknowledge packet");
+  mips_error (_("Remote did not acknowledge packet"));
 }
 
 /* Receive and acknowledge a packet, returning the data in BUFF (which
@@ -1037,7 +1037,7 @@ mips_receive_packet (char *buff, int throw_error, int timeout)
       if (mips_receive_header (hdr, &garbage, ch, timeout) != 0)
        {
          if (throw_error)
-           mips_error ("Timed out waiting for remote packet");
+           mips_error (_("Timed out waiting for remote packet"));
          else
            return -1;
        }
@@ -1077,7 +1077,7 @@ mips_receive_packet (char *buff, int throw_error, int timeout)
          if (rch == SERIAL_TIMEOUT)
            {
              if (throw_error)
-               mips_error ("Timed out waiting for remote packet");
+               mips_error (_("Timed out waiting for remote packet"));
              else
                return -1;
            }
@@ -1099,7 +1099,7 @@ mips_receive_packet (char *buff, int throw_error, int timeout)
       if (err == -1)
        {
          if (throw_error)
-           mips_error ("Timed out waiting for packet");
+           mips_error (_("Timed out waiting for packet"));
          else
            return -1;
        }
@@ -1159,7 +1159,8 @@ mips_receive_packet (char *buff, int throw_error, int timeout)
       if (serial_write (mips_desc, ack, HDR_LENGTH + TRLR_LENGTH) != 0)
        {
          if (throw_error)
-           mips_error ("write to target failed: %s", safe_strerror (errno));
+           mips_error (_("write to target failed: %s"),
+                       safe_strerror (errno));
          else
            return -1;
        }
@@ -1199,7 +1200,7 @@ mips_receive_packet (char *buff, int throw_error, int timeout)
   if (serial_write (mips_desc, ack, HDR_LENGTH + TRLR_LENGTH) != 0)
     {
       if (throw_error)
-       mips_error ("write to target failed: %s", safe_strerror (errno));
+       mips_error (_("write to target failed: %s"), safe_strerror (errno));
       else
        return -1;
     }
@@ -1287,7 +1288,7 @@ mips_request (int cmd,
              &rpid, &rcmd, &rerrflg, response_string) != 4
       || !read_hex_value (response_string, &rresponse)
       || (cmd != '\0' && rcmd != cmd))
-    mips_error ("Bad response from remote board");
+    mips_error (_("Bad response from remote board"));
 
   if (rerrflg != 0)
     {
@@ -1363,7 +1364,7 @@ mips_enter_debug (void)
     char buff[DATA_MAXLEN + 1];
 
     if (mips_receive_packet (buff, 1, 3) < 0)
-      mips_error ("Failed to initialize (didn't receive packet).");
+      mips_error (_("Failed to initialize (didn't receive packet)."));
   }
 }
 
@@ -1413,7 +1414,7 @@ mips_initialize (void)
 
   if (mips_initializing)
     {
-      warning ("internal error: mips_initialize called twice");
+      warning (_("internal error: mips_initialize called twice"));
       return;
     }
 
@@ -1487,7 +1488,7 @@ mips_initialize (void)
          }
          break;
        case 4:
-         mips_error ("Failed to initialize.");
+         mips_error (_("Failed to initialize."));
        }
 
       if (mips_expect (mips_monitor_prompt))
@@ -1598,7 +1599,7 @@ seen from the board via TFTP, specify that name as the third parameter.\n"));
        {
          udp_desc = serial_open (remote_name);
          if (!udp_desc)
-           perror_with_name ("Unable to open UDP port");
+           perror_with_name (_("Unable to open UDP port"));
          udp_in_use = 1;
        }
       else
@@ -1741,7 +1742,7 @@ static void
 mips_detach (struct target_ops *ops, char *args, int from_tty)
 {
   if (args)
-    error ("Argument given to \"detach\" when remotely debugging.");
+    error (_("Argument given to \"detach\" when remotely debugging."));
 
   pop_target ();
 
@@ -1848,7 +1849,7 @@ mips_wait (struct target_ops *ops,
   rstatus = mips_request ('\000', 0, 0, &err, -1, buff);
   mips_wait_flag = 0;
   if (err)
-    mips_error ("Remote failure: %s", safe_strerror (errno));
+    mips_error (_("Remote failure: %s"), safe_strerror (errno));
 
   /* On returning from a continue, the PMON monitor seems to start
      echoing back the messages we send prior to sending back the
@@ -2046,7 +2047,7 @@ mips_fetch_registers (struct target_ops *ops,
            val = mips_request ('r', pmon_reg, 0,
                                &err, mips_receive_wait, NULL);
          if (err)
-           mips_error ("Can't read register %d: %s", regno,
+           mips_error (_("Can't read register %d: %s"), regno,
                        safe_strerror (errno));
        }
     }
@@ -2085,7 +2086,8 @@ mips_store_registers (struct target_ops *ops,
                val,
                &err, mips_receive_wait, NULL);
   if (err)
-    mips_error ("Can't write register %d: %s", regno, safe_strerror (errno));
+    mips_error (_("Can't write register %d: %s"), regno,
+                safe_strerror (errno));
 }
 
 /* Fetch a word from the target board.  Return word fetched in location
@@ -2319,14 +2321,14 @@ mips_create_inferior (struct target_ops *ops, char *execfile,
 
   if (args && *args)
     {
-      warning ("\
-Can't pass arguments to remote MIPS board; arguments ignored.");
+      warning (_("\
+Can't pass arguments to remote MIPS board; arguments ignored."));
       /* And don't try to use them on the next "run" command.  */
       execute_command ("set args", 0);
     }
 
   if (execfile == 0 || exec_bfd == 0)
-    error ("No executable file specified");
+    error (_("No executable file specified"));
 
   entry_pt = (CORE_ADDR) bfd_get_start_address (exec_bfd);
 
@@ -2578,8 +2580,8 @@ mips_common_breakpoint (int set, CORE_ADDR addr, int len, enum break_type type)
          /* Clear the table entry and tell PMON to clear the breakpoint.  */
          if (i == MAX_LSI_BREAKPOINTS)
            {
-             warning ("\
-mips_common_breakpoint: Attempt to clear bogus breakpoint at %s\n",
+             warning (_("\
+mips_common_breakpoint: Attempt to clear bogus breakpoint at %s"),
                       paddress (target_gdbarch, addr));
              return 1;
            }
@@ -2593,8 +2595,8 @@ mips_common_breakpoint: Attempt to clear bogus breakpoint at %s\n",
 
          nfields = sscanf (buf, "0x%x b 0x0 0x%x", &rpid, &rerrflg);
          if (nfields != 2)
-           mips_error ("\
-mips_common_breakpoint: Bad response from remote board: %s",
+           mips_error (_("mips_common_breakpoint: "
+                       "Bad response from remote board: %s"),
                        buf);
 
          return (mips_check_lsi_error (addr, rerrflg));
@@ -2646,8 +2648,8 @@ mips_common_breakpoint: Bad response from remote board: %s",
          nfields = sscanf (buf, "0x%x %c 0x%x 0x%x",
                            &rpid, &rcmd, &rresponse, &rerrflg);
          if (nfields != 4 || rcmd != cmd || rresponse > 255)
-           mips_error ("\
-mips_common_breakpoint: Bad response from remote board: %s",
+           mips_error (_("mips_common_breakpoint: "
+                       "Bad response from remote board: %s"),
                        buf);
 
          if (rerrflg != 0)
@@ -2718,8 +2720,8 @@ mips_common_breakpoint: Bad response from remote board: %s",
                        &rpid, &rcmd, &rerrflg, &rresponse);
 
       if (nfields != 4 || rcmd != cmd)
-       mips_error ("\
-mips_common_breakpoint: Bad response from remote board: %s",
+       mips_error (_("mips_common_breakpoint: "
+                   "Bad response from remote board: %s"),
                    buf);
 
       if (rerrflg != 0)
@@ -2757,7 +2759,7 @@ send_srec (char *srec, int len, CORE_ADDR addr)
       switch (ch)
        {
        case SERIAL_TIMEOUT:
-         error ("Timeout during download.");
+         error (_("Timeout during download."));
          break;
        case 0x6:               /* ACK */
          return;
@@ -2767,7 +2769,8 @@ send_srec (char *srec, int len, CORE_ADDR addr)
                              paddress (target_gdbarch, addr));
          continue;
        default:
-         error ("Download got unexpected ack char: 0x%x, retrying.\n", ch);
+         error (_("Download got unexpected ack char: 0x%x, retrying."),
+                ch);
        }
     }
 }
@@ -3509,7 +3512,7 @@ mips_load (char *file, int from_tty)
 
   /* Get the board out of remote debugging mode.  */
   if (mips_exit_debug ())
-    error ("mips_load:  Couldn't get into monitor mode.");
+    error (_("mips_load:  Couldn't get into monitor mode."));
 
   if (mips_monitor != MON_IDT)
     pmon_load_fast (file);