Use size_t rather than bfd_size_type

[deliverable/binutils-gdb.git] / ld / ld.texinfo

diff --git a/ld/ld.texinfo b/ld/ld.texinfo
index b2b99ab66054ba5bc448908b5754a777bed0404b..bc16764b0554851217316c438ada863843915307 100644 (file)
--- a/ld/ld.texinfo
+++ b/ld/ld.texinfo
@@ -1213,6 +1213,11 @@ This option overrides linker backend default.  It can be used to avoid
 dynamic relocations against undefined weak symbols in executable.
 Supported for i386 and x86-64.
 
+@item noreloc-overflow
+Disable relocation overflow check.  This can be used to disable
+relocation overflow check if there will be no dynamic relocation
+overflow at run-time.  Supported for x86_64.
+
 @item call-nop=prefix-addr
 @itemx call-nop=prefix-nop
 @itemx call-nop=suffix-nop
@@ -3669,6 +3674,25 @@ an error and returns a non-zero exit status.  Note that the
 @code{NOCROSSREFS} command uses output section names, not input section
 names.
 
+@item NOCROSSREFS_TO(@var{tosection} @var{fromsection} @dots{})
+@kindex NOCROSSREFS_TO(@var{tosection} @var{fromsections})
+@cindex cross references
+This command may be used to tell @command{ld} to issue an error about any
+references to one section from a list of other sections.
+
+The @code{NOCROSSREFS} command is useful when ensuring that two or more
+output sections are entirely independent but there are situations where
+a one-way dependency is needed. For example, in a multi-core application
+there may be shared code that can be called from each core but for safety
+must never call back.
+
+The @code{NOCROSSREFS_TO} command takes a list of output section names.
+The first section can not be referenced from any of the other sections.
+If @command{ld} detects any references to the first section from any of
+the other sections, it reports an error and returns a non-zero exit
+status.  Note that the @code{NOCROSSREFS_TO} command uses output section
+names, not input section names.
+
 @ifclear SingleFormat
 @item OUTPUT_ARCH(@var{bfdarch})
 @kindex OUTPUT_ARCH(@var{bfdarch})
@@ -6824,6 +6848,11 @@ The @samp{--long-plt} option enables the use of 16 byte PLT entries
 which support up to 4Gb of code.  The default is to use 12 byte PLT
 entries which only support 512Mb of code.
 
+@kindex --no-apply-dynamic-relocs
+@cindex AArch64 rela addend
+The @samp{--no-apply-dynamic-relocs} option makes AArch64 linker do not apply
+link-time values for dynamic relocations.
+
 @ifclear GENERIC
 @lowersections
 @end ifclear